Cardone 79-7542V Engine Control Module

Cardone 79-7542V Engine Control Module

The Cardone 79-7542V is a remanufactured engine control module built for precise OE-style fit and electronic performance. It is designed for the 2006 Chrysler Pacifica with OE number 4727 542AH, and it requires vehicle-specific flash programming with accurate VIN and mileage data.

Key Features

• Remanufactured Original Equipment-style ECM for direct vehicle fit
• Four rectangular connectors with 38-pin male terminals
• Aluminum housing for durable module construction
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability
• On-car validation is used to verify durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use

Product Details

Cardone Engine Control Module 79-7542V is part of the Cardone remanufactured electronic and powertrain control module line, which focuses on correcting common failure points found in original units. The module is reverse engineered to identify design weaknesses, then rebuilt at Cardone’s Philadelphia manufacturing plant with attention to electrical integrity and long-term operation. This part cross-references Chrysler OE numbers such as 4727542AH and 04727542AH for the same application.

Compatible with 2006 Chrysler Pacifica, this ECM is a direct-fit replacement for vehicles using OE # 4727 542AH. Flash programming is required, and the vehicle must be programmed with the correct VIN and mileage during service. The Cardone 79-7542V is a practical choice when replacing a failed Chrysler Pacifica engine control module and restoring proper engine management communication.

What This ECM Helps Address

• No-start or hard-start conditions related to ECM failure
• Check engine light concerns caused by internal module faults
• Driveability issues tied to incorrect fuel or ignition control
• Communication problems between the ECM and vehicle systems
• Intermittent electrical faults caused by damaged internal solder joints

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For this Chrysler application, VIN programming is required because the part carries a “V” suffix. Confirm the OE number on the original module and make sure the replacement crosses correctly to the Cardone part number 79-7542V before installation.

Because flash programming is required, follow an OE-approved service procedure and use the correct programming data for the vehicle. Accurate VIN and mileage information are required for setup.

Quality Assurance

Each Cardone 79-7542V ECM is tested with automated computer equipment or bench-tested, depending on application, to confirm proper operation. Cardone’s remanufacturing process includes re-soldering or replacement of critical components and on-car validation to check durability and performance before release.