Cardone 79-7913 Engine Control Module

Remanufactured ECM for Dodge B150 and B250

Cardone 79-7913 is a remanufactured engine control module built for 1988 Dodge B150 and 1988 Dodge B250 applications with OE numbers 4379913 and 4379929. It is pre-programmed at the factory for the listed fitments and is designed to restore proper engine management after an original module failure.

Key Features

• Remanufactured Original Equipment-style engine control module for a direct vehicle fit
• Fits 1988 Dodge B150 and 1988 Dodge B250, N/A position
• Two connectors with rectangular connector shape
• Plastic housing with 3 mounting holes
• 14 and 60 terminal configurations with male pin terminals
• No flash programming required and not flashable
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability

Product Details

Cardone Engine Control Module 79-7913 is part of the Cardone remanufactured electronic and powertrain control module line. The remanufacturing process focuses on identifying common failure points, correcting original design weaknesses, and validating the finished unit through automated testing or bench testing depending on the application. For Dodge B150 and Dodge B250 owners, this ECM provides a direct replacement path when the original module has failed and the vehicle needs restored engine control performance.

This part cross-references Dodge OE numbers 4379913 and 4379929 for the same application.

Common Problems This ECM Can Address

• No-start condition caused by a failed engine control module
• Intermittent drivability issues related to internal ECM faults
• Check engine concerns tied to module electronics failure
• Loss of proper fuel or ignition control from a damaged control unit
• Vehicle performance problems after the original ECM has been diagnosed as faulty

Installation Notes and Tips

Before replacing the original ECM or PCM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford Engineering ID or Chrysler OE reference only when applicable to your vehicle family, and follow the correct service procedure for programming or anti-theft relearn steps if required by the vehicle system. For these 1988 Dodge B150 and B250 applications, the module is pre-programmed at the factory.

Quality Assurance

Each Cardone remanufactured control module is 100% computer tested to confirm operation before release. Cardone also validates durability and performance through on-car testing where applicable, and its remanufacturing process reduces the energy and raw material needed for a new part by 80%.