Cardone 79-8026 Engine Control Module

Remanufactured ECM for Jeep Grand Cherokee

This Cardone Engine Control Module is a remanufactured replacement for the 1995 Jeep Grand Cherokee with OE number 56028026. Built for direct vehicle fitment, Cardone Part Number 79-8026 is pre-programmed at the factory for the listed application and is tested to help restore proper engine management performance.

Key Features

• Fits 1995 Jeep Grand Cherokee, N/A
• Cardone Engine Control Module, Part Number 79-8026
• Remanufactured Original Equipment-style replacement for the listed OE application
• One rectangular connector with 60 male pin terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Factory pre-programmed for the listed Jeep application
• Computer tested and on-car validated for durability and performance
• Re-soldered or replaced critical components for improved electrical integrity

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, component correction, and testing. For this Jeep Grand Cherokee application, Part Number 79-8026 is built to match the original module’s fit and electrical layout, helping maintain correct communication between the engine management system and vehicle electronics. This part cross-references Jeep 56028026 for the same application.

Common Problems This ECM Can Address

• No-start condition related to a failed engine control module
• Intermittent stalling or rough engine operation caused by internal ECM faults
• Check engine light concerns tied to module failure
• Loss of injector, ignition, or sensor control from a damaged control unit
• Driveability issues after confirming wiring, grounds, and related components are in good condition

Installation Notes

Before replacing the original ECM, verify that the root cause has been corrected. Poor grounds, power supply issues, damaged wiring harnesses, and shorted relays or solenoids can damage the replacement unit if left unresolved. Confirm the OE number and connector layout match the vehicle before installation. For 1995 Jeep Grand Cherokee applications, follow OE service procedures and check all related engine management inputs and outputs during diagnosis.

Quality Assurance

Each Cardone remanufactured module is computer tested, and critical internal components are re-soldered or replaced during the remanufacturing process. The brand’s Philadelphia manufacturing process includes validation steps aimed at restoring reliable operation for the listed application. Cardone Part Number 79-8026 is designed to meet or exceed OE performance expectations for the specified Jeep Grand Cherokee fitment.