Cardone 79-8030 Engine Control Module

Remanufactured ECM for 1995 Jeep Grand Cherokee

Restore engine management performance with this Cardone remanufactured Engine Control Module for the 1995 Jeep Grand Cherokee. Built for direct OE-style fitment, Cardone Part Number 79-8030 is pre-programmed at the factory for the listed application and is engineered to address common control-module failures with a tested replacement.

Key Features

• Remanufactured Engine Control Module (ECM) for the 1995 Jeep Grand Cherokee
• Cardone Part Number 79-8030 for OE-style replacement
• Pre-programmed at the factory for the listed Jeep application
• 1 rectangular connector, 60 male pin terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Reverse-engineered remanufacturing process addresses original design weaknesses
• Critical components are re-soldered or replaced, then computer tested for function

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are tested to meet or exceed original equipment performance. For this application, the module is built around the original design, with critical electrical points reworked at Cardone’s Philadelphia manufacturing plant and validated through computer testing and on-car vehicle validation. This 1995 Jeep Grand Cherokee ECM is listed with OE number 56028030 and is intended for direct replacement use on the specified vehicle.

This part cross-references Jeep 56028030 for the same application.

Common Problems This ECM Can Address

• No-start or intermittent start conditions caused by a failed engine control module
• Driveability issues related to unstable ECM output or internal circuit faults
• Check engine concerns tied to control-module malfunction
• Electrical problems traced to poor solder joints or weakened internal connections
• Repeat failures after diagnosing the original module as the source of the issue

Installation Notes

Fits 1995 Jeep Grand Cherokee, N/A, with OE # 56028030. Verify the original ECM/PCM part number and confirm the vehicle’s wiring, grounds, and power feeds before replacement. Common failure sources include poor grounds, bad wiring harnesses, and shorted solenoids or relays. Because this unit is pre-programmed at the factory for the listed application, flash programming is not required.

Quality Assurance

Each Cardone remanufactured ECM is 100% computer tested, with additional validation performed by application. The remanufacturing process reduces the energy and raw material needed versus producing a new part, while restoring the module to reliable service for the listed Jeep Grand Cherokee application.