Cardone 79-8115 Engine Control Module

Engine Control Module for 1994 Jeep Grand Cherokee

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 79-8115. It is built for the 1994 Jeep Grand Cherokee export application and is pre-programmed at the factory for direct replacement use.

Key Features

• Remanufactured original equipment-style ECM for a precise vehicle fit
• Fits 1994 Jeep Grand Cherokee, N/A, export only
• Pre-programmed at the factory for this application
• 1 rectangular connector, 60 male pin terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability

Product Details

Cardone Engine Control Module 79-8115 is a remanufactured ECM designed to meet or exceed original equipment performance for the 1994 Jeep Grand Cherokee. Cardone’s remanufacturing process focuses on identifying common failure points, correcting original design weaknesses, and restoring electrical integrity through re-soldering or replacement of critical components. This approach supports dependable engine control operation in the Jeep Grand Cherokee export application while maintaining OE-style fit and connector layout.

This part cross-references Jeep OE numbers 56028115 and 56029302 for the same application.

Common Problems This ECM Can Address

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough engine operation related to ECM faults
• Communication or drivability issues traced to internal module failure
• Electrical problems caused by damaged solder joints or worn internal components
• Replacement needs after diagnosing the original module as the source of failure

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For the 1994 Jeep Grand Cherokee export application, confirm the OE number on the original module matches the correct Cardone part number before installation.

This module is pre-programmed at the factory and does not require flash programming. Use OE service information to confirm connector style, mounting points, and vehicle-specific diagnostic steps before installation.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are engineered to meet or exceed OE performance. Each unit is computer tested, and the remanufacturing process is designed to reduce raw material and energy use compared with producing a new part.