Cardone 79-8250 Engine Control Module

Remanufactured ECM for 1994 Dodge Dakota

Restore engine management performance with this Cardone Engine Control Module, part number 79-8250. It is a remanufactured ECM built for direct replacement in the 1994 Dodge Dakota with OE number 56028250, and it is pre-programmed at the factory for this application.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• Compatible with 1994 Dodge Dakota, N/A, with OE # 56028250
• One rectangular connector with 60 male pin terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to verify durability and performance

Product Details

Cardone Engine Control Module 79-8250 is part of the brand’s remanufactured electronic and powertrain control module line. The remanufacturing process is based on reverse engineering of failed units so known design weaknesses can be corrected before the module is returned to service. For 1994 Dodge Dakota ECM replacement needs, this unit is built to match OE fitment and restore proper engine control operation.

This part cross-references Dodge 56028250 for the same application.

Common Problems This ECM Can Address

• No-start or intermittent start conditions related to engine control failure
• Driveability issues caused by a failed original ECM
• Electrical faults traced to damaged internal module components
• Communication or control problems after the original module has failed
• Performance issues linked to poor internal solder joints or worn circuitry

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, bad power feeds, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford Engineering ID or OE reference on the original module crosses correctly to the replacement part number before installation. This 1994 Dodge Dakota ECM is pre-programmed at the factory and does not require flash programming.

Connector shape is rectangular, with one connector and 60 male pin terminals. Mounting hardware is not included.

Quality Assurance

Each Cardone remanufactured control module is computer tested, and application-specific units are bench-tested or validated on the vehicle as part of the quality process. Re-soldering or replacement of critical components helps improve electrical connection integrity and long-term service life. The remanufacturing process also reduces raw material and energy use compared with producing a new part.