Cardone 79-8271 Engine Control Module

Remanufactured ECM for 1994 Dodge Ram 1500

This Cardone Engine Control Module is a remanufactured replacement for the 1994 Dodge Ram 1500 with OE number 56028271. It is built to restore factory-style engine management performance with a pre-programmed unit that matches the original application.

Cardone 79-8271 is remanufactured in the Philadelphia manufacturing plant, where critical components are re-soldered or replaced and each module is computer tested for reliability. This part is a direct-fit ECM for the 1994 Dodge Ram 1500, designed around the original connector layout and module configuration.

Key Features

• Remanufactured Original Equipment-style engine control module
• Fits the 1994 Dodge Ram 1500 with OE # 56028271
• Pre-programmed at the factory for the listed application
• 1 rectangular connector with 60 male pin terminals
• Plastic housing with 3 mounting holes
• No flash programming required
• Reverse-engineered remanufacturing process addresses original design weaknesses
• Computer tested for functionality and reliability

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, component replacement, and testing. For this application, the 79-8271 is built for the 1994 Dodge Ram 1500 and cross-references Dodge OE numbers 56028270 and 56028271 for the same application. The module uses a single rectangular connector, a 60-terminal male pin layout, and a plastic housing to match the original ECM configuration.

Fits 1994 Dodge Ram 1500, N/A.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to ECM internal faults
• Communication or control problems from damaged module circuitry
• Original module failure related to heat, vibration, or aged solder joints
• Replacement needs for a pre-programmed OE-numbered ECM

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the application before installation. Because this unit is pre-programmed at the factory and does not require flash programming, setup is simplified for the listed vehicle.

Quality Assurance

Each Cardone remanufactured ECM is tested with automated computer equipment or bench-tested, depending on application, to confirm operation before release. The remanufacturing process also reduces raw material and energy use compared with producing a new part, while restoring the module to service for the specified Dodge Ram 1500 application.