Cardone 79-8325 Engine Control Module

Engine Control Module for 1995 Dodge Ram

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 79-8325. It is built for direct replacement in 1995 Dodge Ram 1500, Ram 2500, and Ram 3500 applications with OE numbers 4797739 and 56028325.

Key Features

• Remanufactured ECM for engine and powertrain control
• Direct-fit design with 1 rectangle connector, 60 pin male terminals
• Plastic housing with 3 mounting holes
• Factory pre-programmed for the listed Dodge Ram applications
• Flash programming required: No
• Flashable: No
• Reverse-engineered and corrected for original design weaknesses
• Critical components re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability

Product Details

Cardone Engine Control Module 79-8325 is a remanufactured original equipment-style ECM engineered to meet or exceed OE performance. The Cardone remanufacturing process focuses on identifying common failure points, then reworking critical circuitry at the Philadelphia manufacturing plant to improve electrical integrity and long-term operation. This module is a strong match for 1995 Dodge Ram 1500, Ram 2500, and Ram 3500 trucks that use the listed OE part numbers.

Cardone’s Engine Control Module line is built around remanufactured electronic and powertrain control units that are computer tested and validated before release. For buyers searching for a 1995 Dodge Ram 1500 ECM replacement, a 1995 Dodge Ram 2500 engine control module, or a 1995 Dodge Ram 3500 PCM-style replacement, part number 79-8325 provides a direct OE-style solution.

This part cross-references Dodge OE numbers 4797739 and 56028325 for the same application.

Common Problems This Part Can Address

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough running from internal ECM faults
• Check engine light issues tied to control module failure
• Communication or drivability problems related to damaged circuitry
• Vehicle performance issues after confirming power, ground, and wiring integrity

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford and GM programming notes in the product FAQs do not apply here; this Dodge application is listed as factory pre-programmed and does not require flash programming. Match the OE number on the original module to the Cardone reference before installation.

For 1995 Dodge Ram 1500, 1995 Dodge Ram 2500, and 1995 Dodge Ram 3500 applications, install only after confirming connector style, terminal count, and mounting points match the vehicle.

Quality Assurance

Each Cardone remanufactured ECM is computer tested and validated for durability and performance. The remanufacturing process also reduces energy use and raw material demand compared with producing a new part, while re-soldering critical components helps improve electrical connection quality and service life.