Cardone 79-8351V Engine Control Module

Remanufactured ECM for Chrysler Pacifica

Cardone 79-8351V is a remanufactured engine control module built for the 2005 Chrysler Pacifica with OE references 4748353AA-AH and 68000261AA-AC. It is flash programming required and must be matched to the vehicle with accurate VIN and mileage information for proper setup.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• 4 rectangular connectors with 38-pin male terminals on each connector
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to verify durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on restoring factory-level electronic control after failure. For this 2005 Chrysler Pacifica ECM, the remanufacturing process addresses common internal weak points by inspecting the original unit, correcting design-related issues, and replacing or re-soldering critical electrical connections. The result is a remanufactured Chrysler Pacifica ECM that is built to meet OE performance expectations and support proper engine management after installation. Part number 79-8351V is also referenced for Chrysler applications using the listed OE numbers.

This part cross-references Chrysler OE numbers 4748353AA and 68000261AA for the same application.

What It Helps Fix

• No-start or hard-start conditions caused by a failed ECM
• Check engine light concerns related to control module faults
• Driveability issues tied to incorrect fuel, spark, or sensor control
• Intermittent electrical problems from damaged internal solder joints
• Communication or performance issues after module failure

Installation Notes

• Fits 2005 Chrysler Pacifica, N/A, with OE # 4748353AA-AH and 68000261AA-AC
• Vehicle-specific flash programming is required on or off the vehicle
• Accurate VIN and mileage are required for programming
• Prior to replacement, verify grounds, power feeds, wiring harness condition, and related relays or solenoids
• Chrysler PCM units identified with a “V” suffix require VIN programming

Quality Assurance

Each Cardone remanufactured electronic control module is computer tested, and applications may also receive bench testing or on-car validation depending on the unit. The remanufacturing process is performed at Cardone’s Philadelphia manufacturing plant, where critical components are restored to help deliver reliable operation and consistent fitment for the 2005 Chrysler Pacifica.