Cardone 79-8352V Engine Control Module

Engine Control Module for Chrysler Pacifica

Restore proper engine management with this remanufactured Cardone Engine Control Module, part number 79-8352V. It is built for 2005 Chrysler Pacifica applications and is programmed to match the vehicle-specific flash requirements noted for this OE reference.

Key Features

• Remanufactured Original Equipment-style ECM for exact vehicle fit
• Fits 2005 Chrysler Pacifica with OE references 4748352AA-AH and 68000263AA-AC
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing with 3 mounting holes
• Flash programming required for vehicle-specific setup
• Computer tested and on-car validated for durability and performance
• Critical components are re-soldered or replaced during remanufacturing

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are reverse engineered to identify common failure points and correct original design weaknesses. For this application, the 79-8352V ECM is remanufactured at Cardone’s Philadelphia facility, where critical electrical components are serviced and each unit is tested for function before release. This approach supports reliable engine control on the 2005 Chrysler Pacifica and helps maintain OE-level fit and operation.

This part cross-references Chrysler OE numbers such as 4748352AA and 68000263AA for the same application. The 79-8352V is a direct-fit ECM for Chrysler Pacifica owners replacing a failed engine computer with the correct OE-style unit.

What It Helps Fix

• No-start or hard-start conditions caused by a failed ECM
• Check engine light concerns related to control module faults
• Driveability issues from incorrect fuel or ignition control
• Communication problems between the ECM and vehicle systems
• Intermittent electrical faults traced to internal module failure

Installation Notes

Fits 2005 Chrysler Pacifica, N/A. Vehicle-specific flash programming is required, and accurate VIN and mileage information are needed for setup. Before replacing the original ECM, verify the root cause of the failure, including grounds, power feeds, wiring harness condition, and any shorted relays or solenoids. Confirm the OE number on the original module matches the Cardone reference before installation.

Chrysler PCM units identified with a “V” suffix require VIN programming. If the vehicle uses anti-theft or security relearn procedures, follow the OE service manual for the correct reset process after installation.

Quality Assurance

Cardone remanufactures this ECM to meet or exceed OE performance expectations. Each unit is computer tested, and the remanufacturing process includes re-soldering or replacement of critical components to improve electrical integrity and long-term reliability. The process also reduces raw material and energy use compared with producing a new part.