Cardone 79-8363V Engine Control Module

Remanufactured ECM for Chrysler and Dodge

Cardone 79-8363V is a remanufactured engine control module built for 2004 Chrysler Town & Country, 2004 Dodge Caravan, and 2004 Dodge Grand Caravan applications with OE number 4748 363AA-AH. This ECM is flash programming required and is built to restore proper engine management after module failure.

Key Features

• Remanufactured Original Equipment-style engine control module for a direct vehicle fit
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to verify durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

The Cardone Engine Control Module line focuses on remanufactured electronic and powertrain control modules that are inspected, repaired, and tested to address common failure points found in original units. For this application, Cardone 79-8363V is built around the original module design and requires vehicle-specific flash programming with accurate VIN and mileage information. This part cross-references Chrysler and Dodge OE numbers in the 4748363AA through 4748363AH range for the same application.

Compatible With 2004 Chrysler Town & Country, 2004 Dodge Caravan, and 2004 Dodge Grand Caravan, this ECM is intended for vehicles using OE # 4748 363AA-AH. It is a practical replacement when the original module has failed and the vehicle needs restored engine control, fuel management, and communication with onboard systems.

Common Issues This ECM May Resolve

• No-start or hard-start conditions caused by a failed engine control module
• Check engine light concerns related to internal ECM faults
• Driveability problems tied to incorrect fuel or ignition control
• Communication errors between the ECM and vehicle systems
• Intermittent operation caused by damaged solder joints or internal electronic failure

Installation Notes

• Verify the OE number on the original module before ordering.
• Flash programming is required; accurate VIN and mileage are needed.
• Inspect grounds, power feeds, wiring harnesses, solenoids, and relays before replacing the module.
• Confirm the original failure was not caused by an external electrical issue.
• Follow OE-approved service procedures for programming and initialization.

Quality Assurance

Each Cardone remanufactured ECM is processed at the Philadelphia manufacturing plant, where critical components are repaired or replaced and the unit is tested with computer equipment or bench-tested depending on application. Reverse engineering is used to identify common failure causes and correct original design weaknesses before the module is released for service.