Cardone 79-8473 Engine Control Module

Remanufactured ECM for Dodge Ram

Cardone 79-8473 is a remanufactured Engine Control Module built for specific Dodge Ram applications. It is engineered to restore proper engine management with a direct-fit housing, 60-pin male terminals, and a single rectangular connector.

Compatible with 1994-1995 Dodge Ram 1500, 1994-1995 Dodge Ram 2500, and 1994-1995 Dodge Ram 3500 with OE number 56028473, this ECM is a practical replacement for failed factory control units. The Cardone Engine Control Module line focuses on remanufactured electronic and powertrain control modules that are tested for function and rebuilt with attention to original failure points.

Key Features

• Remanufactured Engine Control Module for OE-style fit and function
• Single rectangular connector with 60 pin male terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for reliability before release
• Fits 1994-1995 Dodge Ram 1500, Ram 2500, and Ram 3500 with OE # 56028473

Detailed Description

Cardone remanufactured electronic and powertrain control modules are rebuilt to meet or exceed original equipment performance targets. The remanufacturing process includes reverse engineering to identify common failure points, then correcting those weaknesses by re-soldering or replacing critical internal components at Cardone’s Philadelphia manufacturing plant. Each unit is computer tested to verify operation, and on-car validation is used on applicable applications to confirm durability and performance. This part number, 79-8473, is a direct replacement choice for Dodge Ram trucks that use OE number 56028473.

This part cross-references Dodge (e.g., 56028349) for the same application.

What It Is Used For

• Restoring engine control after ECM failure
• Replacing a unit with damaged internal circuitry or solder joints
• Addressing drivability problems caused by a faulty control module
• Correcting no-start or intermittent electronic control issues tied to the ECM
• Replacing a module that no longer communicates properly with vehicle systems

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford Engineering ID note does not apply here; for this Dodge application, match the OE number 56028473 and the vehicle’s original module identification before installation. Chrysler PCM units with a “V” suffix require VIN programming, but this listing is an ECM application with no flash programming required. If the vehicle has anti-theft or communication concerns, follow OE service procedures and confirm all related systems are functioning correctly.

Quality Assurance

Cardone remanufactured control modules are built from original equipment cores, tested electronically, and validated for application-specific performance. The remanufacturing process also reduces raw material and energy use compared with producing a new part, supporting a lower-waste repair choice. E-waste designation applies to this electronic component.