Cardone 79-8549V Engine Control Module (ECM)

Remanufactured ECM for Chrysler Applications

Cardone 79-8549V is a remanufactured Engine Control Module built to restore factory-style engine management performance. It is designed for 2000-2001 Dodge Ram 1500 applications with Federal Emission System calibration requirements, including vehicle-specific flash programming with accurate VIN and mileage data.

As part of Cardone’s Engine Control Module line, this unit is remanufactured from an original equipment core and tested for electrical function and durability. It is a direct-fit solution for Ram 1500 owners needing a replacement ECM after control module failure.

Key Features

• Remanufactured original equipment-style ECM for precise vehicle fit
• Vehicle-specific flash programming required on or off the vehicle
• Three rectangular connectors with 32-pin male terminals
• Aluminum housing for OE-style module construction
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested or bench tested, depending on application
• On-car validation used to verify durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use

Product Details

Cardone 79-8549V is engineered for 2000 and 2001 Dodge Ram 1500 trucks with Federal Emission System and OE number 56028544AA-AD. This ECM requires flash programming and accurate VIN and mileage input during setup. Chrysler PCM units identified with a “V” suffix require VIN programming, making correct module setup essential for proper operation. This part cross-references Chrysler 56028544AB and 56028544AC for the same application.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to internal ECM faults
• Communication problems related to damaged module circuitry
• Check engine concerns traced to control module failure
• Calibration or programming issues after ECM replacement

Installation Notes and Tips

• Verify the original failure before replacing the ECM; check grounds, power feeds, wiring harness condition, and related relays or solenoids.
• Confirm the Ford Engineering ID or Chrysler OE number cross-reference only when matching the exact application.
• Flash programming is required, and the vehicle-specific calibration must be completed with accurate VIN and mileage.
• Follow OE-approved service procedures for programming and relearn steps.
• For Chrysler PCM units with a “V” suffix, VIN programming is required.

Quality Assurance

Cardone remanufactures this Engine Control Module to meet or exceed original equipment performance targets. Each unit is inspected, rebuilt with corrected weak points identified through reverse engineering, and tested to confirm functionality before release.