Cardone 79-8580V Engine Control Module

Remanufactured ECM for 2001 Dodge Vans

Cardone 79-8580V is a remanufactured engine control module built for specific 2001 Dodge Ram van applications. It is engineered to restore factory-style engine management performance with OE fitment, flash programming requirements, and application-specific VIN and mileage data.

Compatible With 2001 Dodge Ram 1500 Van, 2001 Dodge Ram 2500 Van, and 2001 Dodge Ram 3500 Van. This part number, 79-8580V, is designed for vehicles that require electronic control module replacement with correct calibration and programming.

Key Features

• Remanufactured Original Equipment-style ECM for direct vehicle fit
• Three rectangular connectors with 32-pin male terminals
• Aluminum housing for OE-style module construction
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability
• Flash programming required for installation
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on restoring electronic and powertrain control performance through remanufacturing, testing, and design correction. For this application, the module is built to meet OE performance expectations and is validated on-car for durability and operation. The 79-8580V is a remanufactured ECM for 2001 Dodge Ram 1500 Van, Ram 2500 Van, and Ram 3500 Van models that require vehicle-specific flash programming and accurate VIN and mileage input.

This part cross-references Dodge OE numbers 56028579AA and 56028579AB for the same application.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to internal ECM faults
• Communication or calibration problems after module failure
• Check engine concerns related to control module malfunction
• Vehicle operation issues after the original ECM has been diagnosed as faulty

Installation Notes

• Verify the original failure before replacement; inspect grounds, power feeds, wiring harness condition, and related relays or solenoids.
• Vehicle-specific flash programming is required on or off the vehicle.
• Accurate VIN and mileage information are required during programming.
• Chrysler PCM units identified with a “V” suffix require VIN programming.
• Use an OE-approved service manual and follow the correct programming procedure for the vehicle.

Quality Assurance

Each Cardone remanufactured ECM is tested with automated computer equipment or bench-tested, depending on application, and validated on the vehicle for durability and performance. The remanufacturing process includes re-soldering or replacement of critical components to improve electrical connection quality and reduce intermittent failures.