Cardone 79-8635V Engine Control Module (ECM)

Remanufactured ECM for Chrysler and Dodge

Cardone 79-8635V is a remanufactured engine control module for select 2005 Chrysler Town & Country and 2005 Dodge Grand Caravan applications. It is built for vehicles that require flash programming and VIN-specific setup, with fitment tied to the OE number 4748 635AC-AJ.

Key Features

• Remanufactured Original Equipment-style engine control module for a direct vehicle fit
• Four rectangular connectors with 38-pin male terminals on each connector
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested for function and reliability before release
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production
• Flash programming required for vehicle-specific calibration

Product Details

The Cardone Engine Control Module line focuses on restoring electronic and powertrain control performance through remanufacturing and testing. For this application, the 79-8635V is built to match the original module’s fit and electrical layout, then validated to help address drivability and control issues tied to a failed ECM. This part cross-references Chrysler OE numbers 4748635AC and 4748635AJ for the same application.

Compatible With 2005 Chrysler Town & Country and 2005 Dodge Grand Caravan, this ECM is intended for vehicles that use OE number 4748 635AC-AJ and require accurate VIN and mileage data during programming. The 79-8635V is a practical replacement when the original module has failed and the vehicle needs a remanufactured control unit with the correct connector configuration.

Common Issues This ECM May Resolve

• No-start condition caused by a failed engine control module
• Check engine light or control module fault codes related to ECM failure
• Intermittent drivability problems from damaged internal solder joints
• Communication issues between the ECM and vehicle systems
• Calibration or programming-related replacement needs after module failure

Installation Notes

• Vehicle-specific flash programming is required on or off the vehicle.
• Accurate VIN and mileage information are required for setup.
• Confirm the OE engineering number on the original module before ordering.
• Inspect grounds, power feeds, wiring harnesses, relays, and solenoids before installing the replacement ECM.
• Some Chrysler PCM applications with a “V” suffix require VIN programming.

Quality Assurance

Cardone remanufactures these control modules at its Philadelphia manufacturing plant, where critical components are reworked and each unit is computer tested to verify operation. The process is designed to meet or exceed OE performance while restoring dependable electronic control for 2005 Chrysler Town & Country and 2005 Dodge Grand Caravan applications.