Cardone 79-8973V Engine Control Module

Remanufactured ECM for 2005 Dodge Durango

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 79-8973V. It is built for the 2005 Dodge Durango with OE number 5602 8973AA through AJ and requires vehicle-specific flash programming using accurate VIN and mileage data.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• Fits 2005 Dodge Durango, N/A
• Cardone part number 79-8973V for direct identification
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing with 3 mounting holes
• Flash programming required; not flashable
• Reverse-engineered remanufacturing process addresses common original design weaknesses
• Critical components are re-soldered or replaced and each unit is computer tested

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are tested for function and durability before release. For this application, the 79-8973V ECM is built to match the original fit and electrical layout used in the 2005 Dodge Durango. The module is intended for OE-numbered applications 5602 8973AA through AJ and supports vehicle-specific flash programming with correct VIN and mileage information.

This part cross-references Dodge OE numbers 56028973AA and 56028973AJ for the same application.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent stalling or loss of engine management communication
• Check engine light concerns tied to internal ECM failure
• Driveability issues related to corrupted module logic or damaged circuitry
• Faults traced to worn solder joints or failed internal electronic components

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For the 2005 Dodge Durango, accurate VIN and mileage are required for flash programming. Confirm the OE number on the original module matches the listed interchange before installation.

Quality Assurance

Cardone remanufactures this ECM using reverse engineering to identify original failure points, then re-solders or replaces critical components at its Philadelphia manufacturing plant. Each unit is tested with computer-based equipment or bench testing, depending on application, to verify operation before it leaves the factory.