Cardone 79-9161V Engine Control Module

Remanufactured ECM for 2004 Ram 1500

Cardone 79-9161V is a remanufactured engine control module for the 2004 Dodge Ram 1500 with OE number 5602 9161AA through AI. It is built for direct vehicle fitment and requires flash programming with accurate VIN and mileage data.

The Cardone Engine Control Module line focuses on restoring factory-level electronic control with remanufactured OE-style units. For this application, the module is aluminum-housed, uses 4 rectangular connectors, and is computer tested to verify operation before release.

Key Features

• Remanufactured original equipment-style ECM for direct fit
• Fits 2004 Dodge Ram 1500, N/A
• Cardone part number 79-9161V
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing with 3 mounting holes
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability
• Flash programming required; VIN and mileage must be accurate

Detailed Description

Cardone remanufactures this engine control module to meet or exceed original equipment performance expectations. The process includes reverse engineering to identify common failure points, then correcting those weaknesses during rebuild. That approach helps deliver stable electronic control for the 2004 Dodge Ram 1500 and supports proper engine management after replacement. This part cross-references Chrysler 56029161AI and Dodge 56029161AA, 56029161AB for the same application.

What It Can Help Fix

• No-start or hard-start conditions related to ECM failure
• Check engine light concerns caused by control module faults
• Driveability issues tied to incorrect fuel or ignition control
• Communication problems caused by a failed powertrain control unit
• Intermittent electrical operation from damaged internal circuitry

Installation Notes

• Fits 2004 Dodge Ram 1500, N/A with OE number 5602 9161AA through AI
• Vehicle-specific flash programming is required on or off the vehicle
• Use accurate VIN and mileage information during programming
• Inspect grounds, power feeds, wiring harnesses, relays, and solenoids before replacement
• Confirm the original ECM is the source of the fault before installation

Quality Assurance

Each Cardone ECM is remanufactured at the Philadelphia manufacturing plant and tested with automated computer equipment or bench-tested, depending on application. On-car vehicle validation is used to confirm durability and performance, and the remanufacturing process reduces raw material and energy use compared with producing a new part.