Cardone 79-9171 Engine Control Module

Remanufactured ECM for 1987 Dodge Dakota

Restore engine management performance with this Cardone remanufactured Engine Control Module, part number 79-9171. It is built for direct fitment on the 1987 Dodge Dakota with OE numbers 4379171 and 4379565, and it arrives pre-programmed at the factory for the listed application.

Cardone remanufactured electronic and powertrain control modules are reverse-engineered to identify common failure points, then rebuilt with critical components re-soldered or replaced. Each unit is computer tested for function and reliability before it leaves the plant.

Key Features

• Fits 1987 Dodge Dakota, N/A
• Cardone Engine Control Module, part number 79-9171
• Remanufactured Original Equipment-style replacement for proper vehicle fit
• 2 connectors with rectangular connector shape
• Plastic housing with 4 mounting holes
• 10 and 14 terminal configurations with male pin terminals
• No flash programming required
• No removable PROM
• Factory pre-programmed for the listed application
• On-car validation and computer testing help confirm durability and performance

Product Details

This Cardone ECM is built for the 1987 Dodge Dakota and is intended to replace the original module using the correct OE cross-reference. The remanufacturing process focuses on known weak points in the original design, with critical electrical connections reworked to improve consistency. For buyers searching for a 1987 Dodge Dakota engine control module, Dodge Dakota ECM replacement, or Cardone 79-9171, this unit provides a direct-match solution for the listed vehicle.

This part cross-references Dodge OE numbers 4379171 and 4379565 for the same application.

Common Problems This ECM Can Address

• No-start condition caused by a failed engine control module
• Intermittent stalling or loss of engine control signals
• Driveability issues tied to internal ECM electrical faults
• Check engine concerns related to module failure
• Hard starting after the original control module has failed

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the listed cross-reference before installation.

This unit is pre-programmed at the factory for the listed application and does not require flash programming. Use an OE-approved service manual for diagnosis and installation procedures.

Quality Assurance

Cardone remanufactured control modules are tested with automated computer equipment or bench-tested, depending on application, and validated on-vehicle for durability and performance. The remanufacturing process also reduces the energy and raw material needed to produce a new part by 80%.