Cardone 79-9425V Engine Control Module

Remanufactured ECM for Chrysler and Dodge

Cardone 79-9425V is a remanufactured engine control module built for direct replacement in select 2008 Chrysler Town & Country and 2008 Dodge Grand Caravan applications. It is flash programmable and pre-programmed at the factory for the listed OE references, making it a practical choice for restoring drivability after ECM failure.

Key Features

• Remanufactured Original Equipment-style engine control module
• Fits 2008 Chrysler Town & Country with OE number 5094 251AD through AL
• Fits 2008 Dodge Grand Caravan with OE number 5094 251AD through AL
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing for OE-style mounting and fit
• Flash programming required; unit is flashable
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability

Product Details

This Cardone Engine Control Module is part of the Cardone remanufactured electronic and powertrain control module line, which focuses on OE-level fit and corrected failure points. The remanufacturing process is based on reverse engineering the original unit to identify common design weaknesses, then rebuilding the module with repaired or replaced critical components. For 2008 Chrysler Town & Country and 2008 Dodge Grand Caravan models, part number 79-9425V is a direct-fit ECM solution for vehicles using OE reference 5094 251AD through AL. This part cross-references Chrysler and Dodge OE numbers in the 5094251AD to 5094251AL range for the same application.

Common Problems This ECM Can Address

• Engine no-start or intermittent start conditions related to ECM failure
• Check engine light concerns caused by control module faults
• Communication or drivability issues tied to damaged module circuitry
• Hard shifting, stalling, or poor engine management from a failed PCM/ECM
• Electrical faults traced to worn solder joints or internal component failure

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. This module requires flash programming, and Chrysler PCM units identified with a “V” suffix need VIN programming. Confirm the OE engineering number on the original module matches the Cardone application before installation. Use an OE-approved service manual for programming and relearn procedures.

Quality Assurance

Cardone remanufactured control modules are tested with automated computer equipment or bench-tested, depending on application, and validated on-vehicle for durability and performance. The remanufacturing process also reduces energy and raw material use compared with producing a new part, supporting a more resource-efficient repair.