Cardone 79-9646V Engine Control Module

Remanufactured ECM for Chrysler and Dodge

Cardone 79-9646V is a remanufactured engine control module for select 2006 Chrysler 300, Dodge Charger, and Dodge Magnum applications. It is built to restore factory engine management performance with vehicle-specific flash programming required for proper operation.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• 4 rectangular connectors with 38-pin male terminals on each connector
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to confirm durability and performance by application
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on correcting common failure points found in original modules. For this application, the 79-9646V is a remanufactured ECM that requires flash programming and accurate VIN and mileage information before installation is completed. This part cross-references Chrysler and Dodge OE numbers such as 5094696AA and 5094696AB for the same application. Compatible with 2006 Chrysler 300, 2006 Dodge Charger, and 2006 Dodge Magnum, this module is built for vehicles that need a direct replacement ECM with OE-level fit and electronic calibration support.

What It Helps Fix

• No-start or hard-start conditions caused by a failed engine control module
• Driveability problems related to incorrect fuel, spark, or sensor control
• Communication faults between the ECM and vehicle systems
• Intermittent electrical issues traced to internal module failure
• Check engine light concerns tied to ECM malfunction

Installation Notes

• Vehicle-specific flash programming is required on or off the vehicle
• Accurate VIN and mileage are necessary for setup
• Inspect grounds, power feeds, wiring harnesses, relays, and solenoids before replacing the module
• Confirm the OE number on the original unit matches the application before ordering
• Chrysler PCM units with a “V” suffix require VIN programming

Quality Assurance

Each Cardone remanufactured ECM is tested with automated computer equipment or bench-tested, depending on application, and then validated on the vehicle for durability and performance. The remanufacturing process includes re-soldering or replacement of critical components to improve electrical connection quality and reduce intermittent failures. Cardone’s Engine Control Module line is built to meet or exceed OE performance expectations.