Cardone 79-9814V Engine Control Module

Cardone Engine Control Module for Neon

Cardone 79-9814V is a remanufactured engine control module for select 1998-1999 Dodge Neon and Plymouth Neon applications with California Emission System calibration. It is built for direct OE-style fitment and requires vehicle-specific flash programming with accurate VIN and mileage data.

Key Features

• Remanufactured ECM for engine management and powertrain control
• Fits 1998-1999 Dodge Neon and 1998-1999 Plymouth Neon, N/A
• Aluminum housing with 2 rectangular connectors
• 40-pin male terminal layout
• Flash programming required; not flashable
• Reverse-engineered and computer tested for function and reliability
• Re-soldered or replaced critical components for improved electrical integrity

Product Details

This Cardone Engine Control Module line is remanufactured from original equipment cores and rebuilt to meet OE performance expectations. For the 1998-1999 Dodge Neon and Plymouth Neon, Part Number 79-9814V is specified for California Emission System vehicles and uses the original connector and terminal configuration for proper integration. Cardone’s remanufacturing process focuses on identifying common failure points, correcting design weaknesses, and validating operation through automated testing or bench testing depending on application.

This part cross-references Dodge 5269815AA and Plymouth 5269815AA for the same application.

Common Problems This ECM Can Address

• No-start or intermittent start conditions caused by ECM failure
• Driveability issues related to incorrect fuel or ignition control
• Check engine light concerns tied to module malfunction
• Communication or calibration problems after module replacement
• Failure from damaged internal solder joints or worn electronic components

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, wiring harness damage, and shorted solenoids or relays. For this application, accurate VIN and mileage information are required for flash programming, and the module must be programmed on or off the vehicle as specified by the service procedure. Confirm the OE number on the original unit matches the Cardone reference before installation.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are reverse engineered to understand original failure modes, then rebuilt with critical components re-soldered or replaced at the Philadelphia manufacturing plant. Each unit is computer tested to verify reliability and support consistent operation in the vehicle.