Cardone 79-9871 Engine Control Module

Engine Control Module for 1989 Dodge Dakota

This Cardone remanufactured engine control module is built for the 1989 Dodge Dakota with OE numbers 4379871 and 4516471. It is a pre-programmed replacement ECM designed to restore factory-style engine management performance with a direct-fit housing and connector layout.

Key Features

• Remanufactured Original Equipment-style engine control module
• Fits 1989 Dodge Dakota, engine control module application
• Pre-programmed at the factory; flash programming not required
• 2 connectors with rectangular connector shape
• Plastic housing with 3 mounting holes
• 14 and 60 terminal configurations with male pin terminals
• Re-soldered or replaced critical components for improved electrical integrity
• Computer tested for functionality and reliability

Product Details

Cardone Engine Control Module 79-9871 is a remanufactured ECM engineered to meet or exceed original equipment performance expectations. The remanufacturing process focuses on identifying common failure points, correcting design weaknesses, and restoring dependable operation. This unit is a direct replacement for the 1989 Dodge Dakota and cross-references OE part numbers 4379871 and 4516471 for the same application. Cardone 79-9871 is also built with an earth-conscious process that reduces the raw material and energy demand associated with producing a new module.

Fits 1989 Dodge Dakota, N/A. This part cross-references Dodge OE numbers 4379871 and 4516471 for the same application.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to internal ECM faults
• Communication or signal problems related to damaged module circuitry
• Faults caused by worn solder joints or failed internal components
• Replacement needs after diagnosing poor power, ground, or wiring-related ECM damage

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, poor power supply, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the correct Cardone application before installation. This unit is pre-programmed at the factory and does not require flash programming. For Chrysler PCM applications with a V suffix, VIN programming may be required; review vehicle-specific service information before installation.

Quality Assurance

Each Cardone remanufactured electronic and powertrain control module is computer tested, and critical internal components are re-soldered or replaced at the Philadelphia manufacturing plant. On-car validation is used to verify durability and performance, helping ensure the module is ready for service in the 1989 Dodge Dakota application.