Cardone 79-9927 Engine Control Module

Engine Control Module for 1989 Dodge Dakota

Cardone 79-9927 is a remanufactured engine control module built for the 1989 Dodge Dakota with OE number 4379927. This ECM is pre-programmed at the factory for the listed application and is designed to restore proper engine management after a module failure.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• Fits 1989 Dodge Dakota, N/A
• Pre-programmed at the factory for the listed application
• 2 rectangular connectors with 14 and 60 terminals
• Plastic housing with 3 mounting holes
• Not flashable and does not require flash programming
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability

Detailed Description

Cardone Engine Control Module 79-9927 is a remanufactured ECM for the 1989 Dodge Dakota, engineered to meet or exceed original equipment performance for the OE 4379927 application. Cardone’s remanufacturing process focuses on identifying common failure points, correcting design weaknesses, and restoring electrical integrity through component replacement and re-soldering at its Philadelphia manufacturing plant. The result is a direct-fit control module for the 1989 Dodge Dakota that is validated through automated testing and on-car performance checks where applicable.

This part cross-references Dodge 4379927 for the same application.

Common Problems This ECM Can Address

• No-start or intermittent start conditions caused by a failed engine control module
• Rough running, stalling, or inconsistent engine control signals
• Check engine concerns related to internal ECM failure
• Electrical faults traced to damaged solder joints or internal module wear
• Driveability issues after confirming power, ground, and wiring integrity

Installation Notes and Tips

Before replacing the original ECM, verify that the root cause has been identified. Common failure sources include poor grounds, weak power feeds, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford Engineering ID-style equivalent for your application is not needed here; for this Dodge application, verify the OE number 4379927 and the vehicle details match the listing. Because this module is pre-programmed at the factory and not flashable, no flash programming is required.

For Chrysler PCM applications with a V suffix, VIN programming may be required. If your vehicle uses anti-theft or security relearn procedures, follow the OE service manual for the correct reset process before and after installation.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are built to restore OE-level operation through controlled remanufacturing, electrical rework, and computer-based testing. The process also reduces raw material and energy use compared with producing a new part, while maintaining application-specific fit and function for the listed vehicle.