Cardone 79-9956 Engine Control Module

Engine Control Module for 1989 Dodge Dakota

This Cardone remanufactured engine control module is built for direct replacement in the 1989 Dodge Dakota with OE number 4379956. It is a pre-programmed ECM designed to restore proper engine management after a failed original unit.

Key Features

• Remanufactured Original Equipment-style fit for the 1989 Dodge Dakota
• Cardone Engine Control Module, part number 79-9956
• 2 connectors with rectangle connector shape
• Plastic housing with 3 mounting holes
• 14 and 60 terminal configurations with male pin terminals
• Factory pre-programmed; flash programming required: no
• Reverse-engineered remanufacturing process addresses original design weaknesses
• Critical components are re-soldered or replaced, then computer tested for function

Product Details

Cardone remanufactured electronic and powertrain control modules are engineered to meet or exceed original equipment performance. For this ECM, Cardone uses failure analysis to identify common weak points, then reworks critical circuitry at its Philadelphia manufacturing plant. The result is a remanufactured control module that supports reliable engine operation in the 1989 Dodge Dakota and helps maintain proper drivability after ECM replacement. Part number 79-9956 is also referenced for OE application 4379956.

This part cross-references Dodge 4379956 for the same application.

What It Can Help Resolve

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough running tied to ECM faults
• Check engine concerns related to internal module failure
• Driveability issues after confirming power, ground, and wiring integrity
• Replacement needs for a damaged or nonfunctional original ECM

Installation Notes

Before replacing the original ECM, verify that the root cause is not a poor ground, power supply issue, damaged wiring harness, or a shorted relay or solenoid. Confirm connector style, terminal count, and OE number match the vehicle before installation. This module is pre-programmed at the factory and does not require flash programming.

For Chrysler PCM applications, units identified with a “V” suffix require VIN programming. Always follow an OE-approved service procedure for vehicle-specific programming, theft deterrent relearn, or diagnostic steps if required by the application.

Quality Assurance

Each Cardone remanufactured ECM is 100% computer tested or bench-tested, depending on application, and on-car validation is used to confirm durability and performance. The remanufacturing process also reduces energy and raw material use compared with producing a new part, supporting a more resource-efficient repair.