Carlson H9415-2 Brake Bleeder Screw - Front

Carlson Brake Bleeder Screw H9415-2

The Carlson H9415-2 brake bleeder screw is a direct-fit brake hardware component for bleeding air from the hydraulic system. It is placed at the highest point of the caliper or wheel cylinder so trapped air can be released during brake service.

Compatible with select Ford and Mazda front brake applications, including Ford F-150, Ford Ranger, Ford Bronco, Ford Aerostar, and Mazda Navajo models across multiple years. The H9415-2 is a practical replacement when servicing front brakes on vehicles that require a brake bleeder screw for proper system bleeding.

Key Features

• Brake bleeder screw for front brake service
• Helps purge air from the brake line during bleeding
• Designed for placement at the highest point of the caliper or cylinder
• Fits a wide range of Ford and Mazda front applications
• Carlson brake hardware part number H9415-2

Detailed Description

Brakes depend on sealed hydraulic pressure, and air in the line can reduce pedal feel and braking response. The Carlson H9415-2 brake bleeder screw is built for front brake applications where a serviceable bleeder is required to vent air during maintenance. It is a fitment-based replacement for vehicles such as the Ford F-150, Ford Ranger, Ford Bronco, Ford Aerostar, and Mazda Navajo, along with other listed Ford and Mazda models. If you are searching for a brake bleeder screw for Ford F-150 front brakes or a Carlson H9415-2 replacement for Ford Ranger front brake service, this part matches the listed applications.

This part cross-references common brake hardware applications for the same use case.

What It Helps Address

• Air trapped in the brake line after brake repair
• Soft or inconsistent brake pedal feel caused by incomplete bleeding
• Service replacement for a damaged or corroded bleeder screw
• Front brake maintenance on listed Ford and Mazda vehicles
• Brake bleeding procedures that require a functional bleeder at the caliper or cylinder

Installation Notes and Tips

Install the bleeder screw in the correct front brake location listed for your vehicle and follow the factory bleeding sequence. Clean the surrounding area before removal, and verify thread engagement and sealing before returning the vehicle to service. Use the vehicle’s service information to confirm the exact brake hardware application before installation.

Quality Assurance

Carlson brake hardware is designed as a service replacement for brake system maintenance. The H9415-2 follows the listed fitment data for confirmed Ford and Mazda front applications.