Centric 116.33004 Disc Brake Pad Wear Sensor - Front or Rear

Centric Brake Pad Wear Sensor Wire

Centric Premium Brake Pad Sensor Wires are factory replacement disc brake pad wear sensors built for application-specific fit and function. This Centric 116.33004 sensor wire is used on select Porsche, Audi, and Volkswagen brake systems where pad wear monitoring is part of the original equipment setup.

Compatible With Porsche Cayenne and Panamera applications, as well as Audi Q7 and Volkswagen Touareg rear brake setups, this sensor wire supports accurate brake pad wear indication when the original sensor is damaged or worn. The Centric Premium Brake Pad Sensor Wires line focuses on OE-style replacement for vehicles that require exact routing and connector fit.

Key Features

• Factory replacement disc brake pad wear sensor wire
• Application-specific fit for proper routing and connection
• Used on rear and front brake configurations, depending on vehicle application
• Centric part number 116.33004
• Cross-references Hella Pagid 355250701 for the same application

Detailed Description

Centric Premium Brake Pad Sensor Wires are engineered as direct replacement sensor leads for vehicles equipped with electronic brake pad wear monitoring. The 116.33004 part is listed for multiple Porsche Cayenne and Panamera brake configurations, including rear applications and select front applications, plus rear fitment on Audi Q7 and Volkswagen Touareg models. Because brake wear sensor routing and connector style vary by platform, application-specific fitment is important for correct warning-light operation and secure installation.

This part number, 116.33004, is also associated with OE-style interchange references used across related European brake applications. For buyers searching by vehicle, this sensor wire is a relevant replacement for Porsche Cayenne rear brake wear sensor needs and Porsche Panamera brake wear sensor service, along with Audi Q7 rear brake wear sensor and Volkswagen Touareg rear brake wear sensor applications.

What It Helps Address

• Brake pad wear warning light staying on after pad service
• Damaged or broken brake pad sensor wiring
• Incorrect sensor fit after brake component replacement
• Intermittent pad wear signal from worn sensor leads
• Need for an OE-style replacement on Porsche Cayenne, Porsche Panamera, Audi Q7, or Volkswagen Touareg

Installation Notes and Tips

Verify the brake rotor, caliper, and position notes against your vehicle before ordering. This sensor wire is listed for specific rear and front brake configurations, including certain Porsche Cayenne and Panamera setups. Inspect the existing connector, wire routing, and sensor mounting points before installation, and replace the sensor if the original lead is cut, abraded, or no longer reads correctly.

Quality Assurance

Centric describes this line as high-quality factory replacement sensor wiring built for application-specific fit and function. The part is intended to match the original brake wear sensor layout used on the listed vehicles, supporting reliable brake pad wear monitoring when installed on the correct application.