Centric 120.83008 Disc Brake Rotor - Front or Rear

Centric Premium Disc Brake Rotor Overview

Centric Premium Disc Brake Rotor 120.83008 is a vented, smooth-surface rotor built for vehicles that use a 15.000-inch outside diameter and a 5-lug, behind-the-hub mounting design. It is engineered for direct brake service on applications such as Honda Civic and Acura Integra fitments where corrosion resistance and consistent rotor dimensions matter.

The Centric Premium Disc Brake Rotors line focuses on long-term protection against rust, making it a practical choice for daily-driven vehicles exposed to moisture, road salt, and temperature changes. Part number 120.83008 is built to match the specified hub and bolt pattern dimensions for accurate brake service.

Key Features

• Part number: 120.83008
• Centric Premium Disc Brake Rotors product line
• Vented rotor construction for heat management
• Smooth surface type
• 15.000-inch outside diameter
• 5 bolt holes and 5 mounting bolt holes
• Behind-the-hub mounting type
• Electrocoated finish for corrosion protection
• ABS tone ring not included
• Bearings not included

Rotor Construction and Finish

This rotor uses an electrocoating finish rather than a basic phosphate coating. Centric states that the e-coat is applied electrostatically and is built to resist corrosion after extended salt-water exposure, which helps preserve the rotor surface before and after installation. The vented design, 1.435-inch nominal thickness, and 1.320-inch discard thickness support proper brake service when replacing worn front or rear brake rotors on the correct application.

For shoppers searching for a Honda Civic brake rotor, Acura Integra disc brake rotor, or Centric 120.83008 replacement rotor, this part is built around the listed dimensions: 381 mm outside diameter, 362 mm center hole diameter, and 323.9 mm bolt circle diameter.

Common Problems This Rotor Can Address

• Brake pulsation caused by rotor wear or thickness variation
• Visible rotor rust on exposed braking surfaces or hat areas
• Reduced braking consistency from worn or warped rotors
• Noise from uneven rotor surfaces during braking
• Service replacement for rotors that have reached discard thickness

Installation Notes and Fitment

Fits 2001-2005 Honda Civic, position not specified in the provided fitment data.

Fits 2001-2006 Acura Integra, position not specified in the provided fitment data.

Verify outside diameter, center hole diameter, bolt circle diameter, and mounting style before installation. This rotor mounts behind the hub and uses a 5-lug pattern, so it should be matched to the vehicle’s brake system and hub dimensions during service. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Centric Premium Disc Brake Rotors are built with an electrocoated corrosion-resistant finish and published dimensional specifications for brake-service accuracy. The brand’s rotor design emphasizes protection from rust during storage and after installation, supporting long-term service life in demanding driving conditions.