Centric 141.40097 Disc Brake Caliper - Front Right

Centric Front Right Disc Brake Caliper

The Centric Premium Semi-Loaded Disc Brake Caliper, part number 141.40097, is a remanufactured front right caliper built for predictable braking performance and long service life. It is a direct replacement for select Acura and Honda applications, including the Acura RDX and Honda CR-V, Accord Crosstour, and Odyssey.

Centric remanufactures this caliper with a rust-resistant finish, pressure testing, and inspection to help ensure proper operation and fitment. The semi-loaded design includes the mounting bracket and abutment clips where applicable, making it a practical choice for brake service on the front right corner.

Key Features

• Remanufactured floating disc brake caliper for the front right position
• Cast iron caliper body with steel pistons
• 2-piston design with 45.5 mm bore size
• Rust preventative gray finish for corrosion resistance
• Banjo inlet fitting with M10x1.0 inlet thread size
• Bleeder screw included with M10x1.25 thread size
• Mounting bracket included; abutment clips included
• Pressure tested and inspected before release
• Cross-reference part number: Raybestos Brakes FRC11712

Product Details

Centric Premium Semi-Loaded Disc Brake Calipers are part of the Centric brake hydraulics line, focused on OE-style replacement parts for everyday driving and repair work. This 141.40097 caliper uses a floating design with a 45.5/45.5 mm bore and a leading-side configuration for the front right wheel position. The cast iron construction and rust preventative finish help protect the caliper body during normal service exposure, while the included bracket supports proper alignment during installation.

Compatible With 2007-2012 Acura RDX, front right; 2010-2011 Honda Accord Crosstour, front right; 2007-2011 Honda CR-V, front right; and 2005-2010 Honda Odyssey, front right. This part number, 141.40097, is also listed with interchange references used across the aftermarket for the same application.

Common Brake Issues This Caliper Can Address

• Uneven front brake pad wear caused by caliper sticking or poor piston return
• Brake drag from a worn or corroded original caliper
• Brake fluid leakage at the caliper body or bleeder area
• Reduced braking response from a damaged or seized front right caliper
• Noise or vibration related to caliper hardware wear or misalignment

Installation Notes

Verify the front right position, inlet thread size, and bracket style before installation. This caliper uses an M10x1.0 inlet thread and M10x1.25 bleeder screw thread, with a banjo-style inlet fitting. Pads are not included, so inspect the existing pads, rotors, and brake hoses during service and replace any worn components as needed for proper brake system operation.

For best results, bleed the brake system thoroughly after installation and confirm that the caliper slides freely on the bracket. Check fitment against the vehicle application and note that this listing is for the front right side only.

Quality Assurance

Centric remanufactures this caliper, tumble blasts it for a like-new surface condition, then applies an anti-corrosion finish. Each unit is 100% pressure tested and inspected to help confirm proper operation and fitment before it is released for service.