Centric 141.42545 Disc Brake Caliper - Rear Right

Centric Rear Right Disc Brake Caliper

Restore braking performance on compatible Nissan Maxima and INFINITI I30 applications with this Centric Premium Semi-Loaded Disc Brake Caliper, part number 141.42545. This remanufactured rear right caliper is built for predictable operation, corrosion resistance, and a direct-fit replacement on the listed vehicles.

Key Features

• Centric Premium Semi-Loaded Disc Brake Calipers product line
• Remanufactured cast iron floating caliper with a 34 mm steel piston
• Gray rust-preventative finish for added corrosion protection
• 100% pressure tested and inspected for operation and fitment
• Includes mounting bracket, abutment clips, and bleeder screw where applicable
• Rear right position for listed Nissan Maxima and INFINITI I30 fitments
• Part number 141.42545 for catalog and service reference

Product Details

The Centric Premium Semi-Loaded Disc Brake Calipers line focuses on remanufactured brake hydraulics that meet the needs of everyday repair work. This caliper uses a floating design with a single 34 mm piston, cast iron body, and steel piston construction. The anti-corrosion finish helps protect the caliper housing after remanufacturing, while pressure testing and inspection help confirm proper operation before installation. This part cross-references Raybestos Brakes FRC10585 for the same application.

Compatible With 1994-2000 Nissan Maxima, rear right, and 1996-2000 INFINITI I30, rear right. It also matches the specific late-2000 build note for vehicles produced up to September 2000 on the listed Maxima and I30 applications. Use part number 141.42545 when verifying the correct rear brake caliper for these vehicles.

Common Repair Uses

• Leaking or seized rear brake caliper replacement
• Uneven rear brake pad wear caused by caliper sticking
• Brake drag from a worn piston or internal seal issue
• Corrosion-related caliper failure on rear disc brake systems
• Restoration of proper rear braking balance on Maxima and I30 models

Installation Notes

Confirm the rear right position, inlet thread size, and bracket requirement before installation. This caliper uses an M10x1.0 inlet thread and M10-1.00 bleeder screw thread, with a banjo/open inlet fitting style. The mounting bracket is included, while pads are not included. Verify brake hose routing, bleeder orientation, and pad hardware condition during service. For best results, inspect the rotor, pads, and brake fluid condition before completing the repair.

Quality Assurance

Each Centric caliper is remanufactured, tumble blasted, treated with a rust-preventative finish, pressure tested, and inspected to support proper fitment and operation. Centric is a long-established brake component manufacturer known for aftermarket brake systems under the Centric, StopTech, C-Tek, and PosiQuiet labels.