Centric 150.44345 Brake Hydraulic Hose - Rear

Centric Brake Hydraulic Hose for Rear Brake Service

The Centric Premium Brake Hydraulic Hoses line delivers a direct-fit brake hydraulic hose built for rear brake service on select Toyota applications. Part number 150.44345 is a DOT approved replacement hose with metal male and female inverted flare ends, an EPDM rubber outer sleeve, and a preinstalled gasket or seal for a cleaner brake repair.

Compatible with rear brake hose replacement on 1986-1992 Toyota Supra and 1989-1992 Toyota Cressida, this hose supports reliable brake fluid transfer where the original line has aged, cracked, or begun to leak. The Centric Premium Brake Hydraulic Hoses program covers brake hydraulic components across master cylinders, wheel cylinders, hoses, repair kits, and remanufactured boosters.

Key Features

• DOT approved brake hydraulic hose
• Black EPDM rubber outer sleeve
• Metal end fittings with inverted flare connections
• Male end 1 and female end 2 configuration
• End thread size: M10-1.00 at both ends
• Gasket or seal included
• Clip included; washer part number 117.99010 referenced by Centric
• Rear position application for select Toyota models

Product Details

Centric 150.44345 is built as a rear brake hydraulic hose for Toyota Supra and Toyota Cressida applications listed below. The hose measures 395.00 mm overall length and uses metal fittings with inverted flare ends for secure connection at the brake line interface. It does not include mounting hardware, brackets, grommets, or a shield, and it is not Teflon lined. This part cross-references Dorman - First Stop H38412 and Raybestos Brakes BH38412 for the same application.

What This Hose Helps Address

• Brake fluid seepage from a worn rear flexible hose
• Cracking or hardening of an aging rubber brake line
• Restricted brake fluid flow caused by internal hose deterioration
• Soft or inconsistent rear brake pedal response linked to hose wear
• Service replacement for damaged rear brake hose fittings

Installation Notes and Tips

Install this hose in the rear brake position only on the listed Toyota fitments. Verify M10-1.00 thread engagement, flare type, and hose routing before tightening. Because mounting hardware is not included, reuse or source the required vehicle-specific retaining components as needed. After installation, bleed the brake system and inspect all connections for leaks.

Quality Assurance

Centric’s brake hydraulic program is organized to cover a broad range of brake hydraulic service parts, including hoses, cylinders, repair kits, and boosters. Part number 150.44345 is DOT approved and built to meet the requirements of the listed rear brake applications.

Fitment

• Fits 1989-1992 Toyota Cressida, rear.
• Fits 1987-1992 Toyota Supra, rear.
• Fits 1986 Toyota Supra, rear (Fr 1/86).