Centric 150.62355 Brake Hydraulic Hose - Rear

Centric Rear Brake Hydraulic Hose

Centric Premium Brake Hydraulic Hose 150.62355 is a DOT approved rear brake hose built for consistent hydraulic transfer and OE-style service replacement. It uses a black EPDM rubber outer sleeve with metal fittings and an included gasket or seal for a clean brake system repair.

Key Features

• DOT approved brake hydraulic hose for road use
• Black EPDM rubber outer sleeve
• Metal banjo end and metal female end with bubble flare
• Gasket or seal included
• Banjo bolt and clip references available for service matching
• Centric Premium Brake Hydraulic Hoses line for brake hydraulic replacement parts

Product Details

Centric 150.62355 is part of the Centric Premium Brake Hydraulic Hoses line, a brake hydraulic program that covers master cylinders, wheel cylinders, brake hoses, repair kits, and remanufactured power boosters. This rear hose is built with a black EPDM rubber outer sleeve, metal end fittings, and a 12.244-inch overall length. The hose uses a banjo fitting on one end and a female M10-1.00 bubble flare connection on the other, with a gasket or seal included for the connection point.

Compatible With 1991-1998 Saturn SL, rear; 1991-1998 Saturn SL1, rear; 1991-1998 Saturn SL2, rear; 1991-1992 Saturn SC, rear; 1993-1998 Saturn SC1, rear; 1993-1998 Saturn SC2, rear; 1993-1998 Saturn SW1, rear; and 1993-1998 Saturn SW2, rear. If you are replacing a rear brake hose on a Saturn SC1, Saturn SL2, or Saturn SW2, verify the fitting style and hose routing against the original part before installation. This part number is 150.62355.

Common Repair Uses

• Replacing a cracked or aged rear brake hose
• Restoring brake fluid flow to the rear brakes
• Correcting leaks at the hose connection points
• Addressing soft or inconsistent brake pedal response caused by hose deterioration
• Repairing corrosion or wear at the original hose fittings

Installation Notes

Confirm rear position, fitting type, thread size, and hose length before installation. This hose uses a banjo connection with a 10mm thread on one end and an M10-1.00 female bubble flare on the other. Mounting hardware, brackets, grommets, and shields are not included, so reuse or source any required vehicle-specific hardware as needed. Bleed the brake system after installation and inspect all connections for leaks.

Quality Assurance

Centric brake hydraulic components are supported by a broad brake parts program focused on replacement coverage for hydraulic service work. Part number 150.62355 is DOT approved and built to meet brake system service requirements for the listed Saturn rear applications.