Centric 320.46067F Disc Brake Rotor - Rear

Rear Brake Rotor for Mitsubishi Endeavor and Grandis

Centric GCX Elemental Protection Disc Brake Rotors - Full Coating, part number 320.46067F, is a rear solid disc brake rotor built for specific Mitsubishi applications. It combines a fully coated disc finish, coated hat, and smooth surface to support consistent braking performance while helping resist corrosion on exposed rotor surfaces.

Key Features

• Fits 2004-2011 Mitsubishi Endeavor, rear
• Fits 2007-2009 Mitsubishi Grandis, rear
• Centric GCX Elemental Protection Disc Brake Rotors - Full Coating
• Part number 320.46067F
• Fully coated disc finish with coated hat for added surface protection
• Smooth, solid rotor design for rear brake service
• Outside diameter: 11.890 in. / 302.000 mm
• Nominal thickness: 0.398 in. / 10.120 mm
• Discard thickness: 0.331 in. / 8.400 mm
• 5-lug pattern with 4.500 in. bolt circle and 2.717 in. center hole

Product Details

The Centric GCX Elemental Protection Disc Brake Rotors - Full Coating line focuses on corrosion protection across the rotor surfaces, including the disc and hat areas. For Mitsubishi Endeavor and Mitsubishi Grandis rear brake service, part number 320.46067F provides a solid rotor configuration with a smooth friction surface and OE-style dimensions that support proper rotor replacement on the listed applications. This rotor measures 2.311 in. overall height and uses a floating / DIH disc mounting layout with three miscellaneous holes and no ABS tone ring included.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Replacement Reasons

• Rear brake pulsation from rotor wear or thickness variation
• Corrosion on the rotor hat or braking surface
• Reduced braking consistency during stop-and-go driving
• Noise caused by uneven or worn rear rotors
• Service replacement for Mitsubishi Endeavor or Grandis rear brake maintenance

Installation Notes and Tips

Verify rotor dimensions, hub fitment, and rear brake hardware condition before installation. Clean the hub mounting surface thoroughly to reduce runout concerns, and inspect pads, calipers, and guide components at the same time. Confirm the rotor is installed on the rear axle position specified for your vehicle before returning the brake system to service.

Quality Assurance

Centric GCX rotors are built around application-specific sizing and corrosion-protection features for direct-fit brake service on the listed Mitsubishi models. Part number 320.46067F is specified for rear fitment on 2004-2011 Mitsubishi Endeavor and 2007-2009 Mitsubishi Grandis.