Centric 411.90002E Drive Axle Shaft Bearing

Centric Rear Inner Drive Axle Bearing

The Centric C-TEK Standard Axle Shaft, Hub & Wheel Bearings line delivers a precise replacement for driveline service, and part number 411.90002E is built for rear inner applications that demand stable rotation and low friction. It is a direct-fit bearing choice for Porsche 944, Porsche 924, and Volkswagen Beetle rear axle service where correct dimensions matter.

Key Features

• Single-row ball bearing design for rear inner drive axle applications
• High-quality raceway finish helps reduce friction and operating temperature
• Positive roller alignment supports true rolling motion
• Reduced running noise for smoother driveline operation
• Built from quality materials for extended service life
• Dimensions: 30.000 mm inside diameter, 62.000 mm outside diameter, 16.000 mm width

Product Line Details

Centric’s C-TEK Standard Axle Shaft, Hub & Wheel Bearings line focuses on dependable replacement bearings for automotive and light truck wheel hubs and bearings. This 411.90002E bearing follows that approach with a standard-fit design and dimensional accuracy suited to rear inner axle locations.

Detailed Description

Centric 411.90002E is a drive axle shaft bearing with a 1.1811 in. inside diameter, 2.4409 in. outside diameter, and 0.6299 in. width. Those measurements make it a strong match for rear inner bearing service on 1983-1985 Porsche 944, 1977-1982 Porsche 924, and 1968-1979 Volkswagen Beetle rear double joint axle applications. This part cross-references National 206 for the same application. If you are replacing a worn Porsche 944 rear inner bearing or servicing a Volkswagen Beetle rear axle, this bearing provides the dimensional fit and bearing geometry needed for consistent operation.

Common Problems This Bearing Can Address

• Rear axle bearing noise during acceleration or cruising
• Excessive friction from worn raceways
• Rough or uneven wheel-end rotation
• Heat buildup at the rear inner bearing location
• Play or looseness caused by bearing wear

Installation Notes and Tips

Verify the bearing dimensions against the removed part before installation, especially on Porsche 924 rear inner and Porsche 944 rear inner applications. Inspect the axle shaft, hub surfaces, and bearing seats for wear or scoring before assembly. Proper press-fit handling and correct alignment are important to avoid premature bearing damage. For Volkswagen Beetle rear double joint axle service, confirm the rear inner position and related axle configuration before ordering.

Quality Assurance

Centric engineers this C-TEK bearing from quality materials with raceway finishing intended to lower friction and support longer service life. The design also promotes reduced running noise and stable rolling performance for driveline repair work.