Centric 412.40002E Wheel Bearing - Front

Front Wheel Bearing for Honda and Acura

Centric C-TEK Standard Axle Shaft, Hub & Wheel Bearings part number 412.40002E is a front wheel bearing built for select Honda Civic, Acura EL, Acura Integra, and Honda Civic del Sol applications. It uses a double-row ball bearing design with deep groove construction to handle radial and axial loads, while the extended inner race and sealed construction support consistent wheel-end operation.

C-TEK Standard Bearing Line

The Centric C-TEK Standard Axle Shaft, Hub & Wheel Bearings line focuses on practical OE-style replacement coverage across a wide range of wheel hubs and bearings. For drivers and repair shops servicing Honda Civic and Acura front wheel bearing applications, this line provides a straightforward replacement option with the dimensions and construction needed for proper fitment.

Key Features

• Double-row ball bearing design for front wheel applications
• Deep groove construction for radial and axial load handling
• Outer spherical race helps compensate for minor misalignment
• Sealed on both sides with one metal shield
• Extended inner race for the specified hub and axle shaft setup
• Inside diameter: 1.693 in. / 43.000 mm
• Outside diameter: 3.110 in. / 79.000 mm
• Width: 1.614 in. / 41.000 mm
• ABS: No

Detailed Description

Centric 412.40002E is a front wheel bearing engineered for select Honda and Acura vehicles that use a sealed double-row ball bearing assembly. The deep groove design supports both radial and axial loading, while the outer spherical race helps accommodate small alignment variations at the wheel end. With an extended inner race and sealed construction, this bearing matches the dimensional requirements listed for compatible front applications.

Compatible With 1992-2005 Honda Civic, front; 1997-2005 Acura EL, front; 1994-2001 Acura Integra, front; and 1995-1997 Honda Civic del Sol, front. This part cross-references Raybestos Brakes 710030 for the same application. Centric 412.40002E also appears in front fitment for the 2012 Honda Civic.

Common Problems This Part Can Address

• Front wheel bearing noise such as humming or growling
• Excessive wheel-end play or looseness
• Rough rotation caused by worn bearing surfaces
• Seal wear that allows contamination into the bearing assembly
• Fitment issues when replacing a front hub and bearing assembly on listed Honda and Acura models

Installation Notes and Tips

Verify the bearing dimensions, ABS requirement, and front position before installation. Inspect the hub, axle shaft, and surrounding components for wear or damage that could affect bearing life. Proper press-fit procedures and clean mating surfaces are important for a correct wheel-end repair on Honda Civic and Acura front bearing applications.

Quality Assurance

Centric manufactures the C-TEK Standard Axle Shaft, Hub & Wheel Bearings line as a broad OE-style replacement range for wheel-end service. Part number 412.40002E is built to the listed dimensions and construction details for the specified front applications.