Centric 412.40008E Wheel Bearing - Front

Centric Front Wheel Bearing for Honda and Acura

Centric C-TEK Standard Wheel Bearing 412.40008E is a front wheel bearing built for select Honda Pilot and Acura MDX applications. It uses a double-row ball bearing design with deep groove construction to handle radial and axial loads, while the sealed, metal-shielded design helps protect the bearing surfaces in service.

The Centric C-TEK Standard Axle Shaft, Hub & Wheel Bearings line focuses on practical OE-style replacement coverage across a wide range of hubs and bearings. For shoppers searching for a front wheel bearing for 2005-2008 Honda Pilot or 2003-2006 Acura MDX, part number 412.40008E provides a direct-fit option for the listed front applications.

• Double-row ball bearing construction
• Deep groove design for radial and axial load handling
• Outer spherical race helps compensate for minor misalignment
• Sealed on both sides with metal shields
• Front position fitment for select Honda and Acura vehicles
• Inside diameter: 2.008 in. / 51.000 mm
• Outside diameter: 3.504 in. / 89.000 mm
• Width: 1.732 in. / 44.000 mm

Detailed Product Information

Centric 412.40008E is a standard wheel bearing engineered for the front hub assembly on 2005-2008 Honda Pilot and 2003-2006 Acura MDX models. The double-row ball bearing layout supports both radial and axial loading, and the spherical outer race helps account for small alignment variations during operation. With metal shields on both sides, this bearing is built for protected, sealed service in the front driveline and axle area.

This part number, 412.40008E, is a practical choice when replacing a worn front wheel bearing on a Honda Pilot or Acura MDX and when matching the original bearing dimensions matters. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Front wheel bearing noise such as humming or growling
• Excessive play or looseness at the front hub
• Rough wheel rotation caused by bearing wear
• Vibration or instability related to a worn front bearing
• Service replacement for a damaged sealed bearing assembly

Installation Notes and Tips

Verify the bearing dimensions and front position before installation. Clean the hub and surrounding components thoroughly, and inspect the mating surfaces for wear or damage that could affect bearing life. Because this bearing is sealed with metal shields, avoid contaminating the bearing during handling and installation. Confirm ABS requirements before ordering; this part is listed as non-ABS.

Quality Assurance

Centric’s C-TEK Standard line is positioned as a broad OE-style replacement range for axle shaft, hub, and wheel bearing applications. Part number 412.40008E is specified with published dimensions and fitment for the listed Honda and Acura front applications, supporting accurate selection for repair work.