Centric 417.58002 Drive Axle Shaft Seal - Rear Inner

Centric Drive Axle Shaft Seal for Reliable Fluid Control

Centric Premium Axle Shaft, Hub & Wheel Seals part number 417.58002 is a drive axle shaft seal built to retain lubricant and keep contaminants out of the bearing and axle area. With precise dimensions and a premium sealing design, it supports clean operation in driveline and axle service.

Compatible With axle seal service on vehicles such as Honda Civic and Toyota Corolla applications where the specified seal dimensions match the original part.

Key Features

• Inside diameter: 2.750 in. / 69.85 mm
• Outside diameter: 3.883 in. / 98.63 mm
• Width: 0.437 in. / 11.100 mm
• Helps retain grease or oil at the axle shaft interface
• Helps separate lubricants from dirt, moisture, and other contaminants
• Supports sealing between dissimilar fluids or gases in driveline applications

Product Details

Centric Premium Axle Shaft, Hub & Wheel Seals is the product line behind this seal, focused on sealing components used in axle, hub, and wheel service. Part number 417.58002 is specified as a drive axle shaft seal and is sized for applications that require a 2.750-inch inside diameter, 3.883-inch outside diameter, and 0.437-inch width. That dimensional accuracy matters when replacing a worn axle seal on Honda Civic or Toyota Corolla driveline assemblies, where proper sealing helps maintain lubricant level and reduce contamination at the shaft opening.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Seal Addresses

• Gear oil or grease leakage at the axle shaft
• Contamination entering the hub or axle seal area
• Premature wear caused by loss of lubricant retention
• Noise or rough operation related to compromised sealing surfaces
• Service issues after axle shaft or hub maintenance

Installation Notes and Tips

Verify the inside diameter, outside diameter, and width against the original seal before installation. Inspect the shaft, bore, and sealing surface for wear, scoring, or corrosion, and clean the housing thoroughly so the new seal seats evenly. Confirm the replacement matches the vehicle’s axle seal specification before reassembly.

Quality Assurance

Centric Premium seals are engineered for bearing protection and fluid control in driveline sealing applications. Part number 417.58002 is built to support dependable sealing performance when the correct dimensions are matched to the vehicle application.