Dana Spicer 5-760X Drive Axle Shaft Universal Joint - Front Axle at Wheels

Dana Spicer 5-760X Drive Axle Shaft U-Joint

The Dana Spicer 5-760X is a drive axle shaft universal joint built for front axle at wheels applications that demand precise fitment and dependable driveline operation. It uses a 1310WJ/ISR style design with 1.188-inch bearing caps and pre-greased steel construction for service-ready installation.

Spicer HGVF components are engineered for a wide range of vehicle duty cycles, from light-duty trucks and SUVs to heavier commercial and off-highway use. This part number, 5-760X, is a direct replacement option for many Jeep, Ford, Dodge, Chevrolet, GMC, and Mazda front axle applications.

Key Features

• Part number: 5-760X
• OEM series: Spicer 1310WJ
• ISR style drive axle shaft universal joint
• 1.188-inch bearing cap diameter on both ends
• Ground, round bearing caps with steel construction
• Pre-greased with N.L.G.I. Grade 2 grease
• Internal snap ring design included
• Non-greasable design with rubber seals
• Brand line: HGVF

Detailed Description

Built under the Dana Spicer name, the 5-760X focuses on OE-style driveline accuracy and long service life. The 1310WJ series specification, 2.188-inch bearing cap-to-bearing cap length, and ISR configuration make it a strong match for front axle service where correct joint geometry matters. This part cross-references SKF UJ371 and MOOG Driveline Products 377 for the same application.

Compatible vehicle coverage includes many Jeep Wrangler, Jeep Cherokee, Ford F-250, Dodge Ram 1500, and GMC K2500 front axle at wheels applications. It also appears in fitment for Ford Bronco, Ford Ranger, Chevrolet K10, and Dodge W250 configurations across multiple model years.

Common Problems This Part Can Address

• Front axle vibration caused by worn universal joint bearings
• Clunking or driveline play during acceleration or deceleration
• Need for a direct replacement on non-greasable front axle joints
• Noise from dry, loose, or damaged axle shaft U-joints
• Service issues on vehicles using a 1310WJ-style joint

Installation Notes and Tips

• Verify bearing cap diameter, snap ring style, and joint length before installation.
• Confirm the vehicle uses a front axle at wheels application listed in the fitment data.
• Inspect yokes, retaining grooves, and axle shaft surfaces for wear before pressing in the new joint.
• Because this is a non-greasable joint, replacement is the service method when wear develops.
• Match the joint to the exact axle and driveshaft configuration noted for your vehicle.

Quality Assurance

Dana Spicer universal joints are manufactured to support demanding driveline applications with consistent OE-level fit and material quality. The 5-760X is built with steel construction, pre-greased internals, and sealed components to help maintain reliable operation in front axle service.

Fits 1997-2011 Jeep Wrangler, front axle at wheels; 1997-2006 Jeep TJ, front axle at wheels; 1999-2001 Dodge Ram 1500, front axle at wheels; 2000-2001 Jeep Cherokee, front axle at wheels; and additional listed Jeep, Ford, Dodge, Chevrolet, GMC, and Mazda front axle applications.