Delphi ES10822 Oxygen Sensor - Rear or Right

Delphi ES10822 Oxygen Sensor Overview

The Delphi ES10822 oxygen sensor is a heated, 4-wire replacement built with OE heritage and application-specific engineering. It is used on select Toyota Land Cruiser, Toyota Pickup, Toyota Corolla, and Chevrolet Nova applications where accurate exhaust feedback is needed for proper engine management.

Delphi draws on more than a century of OE experience and supplier knowledge to support aftermarket parts that match original equipment expectations. The ES10822 is a direct-fit oxygen sensor for front, rear, and right-side positions depending on vehicle application.

Key Features

• Heated oxygen sensor design for faster operating temperature
• 4-wire configuration for signal and heater circuit operation
• Square connector shape for application-specific fitment
• 18 x 1.5 mm thread size
• Overall length: 230.0 mm
• Package includes the oxygen sensor and instruction sheet
• Position-specific fitment for front, rear, and right locations

Detailed Description

The Delphi ES10822 oxygen sensor helps monitor exhaust oxygen content so the engine control system can adjust fuel delivery and emissions performance. This part number is commonly referenced for Toyota Land Cruiser oxygen sensor replacement, Toyota Pickup rear oxygen sensor service, and select Toyota Corolla and Chevrolet Nova applications. If you are searching for Delphi ES10822, this sensor is built to match the required connector, thread, and heated 4-wire layout for the listed vehicles.

This part cross-references DENSO Auto Parts 234-4150 for the same application.

What This Part Helps Address

• Check engine light related to oxygen sensor performance
• Incorrect air-fuel mixture readings
• Reduced fuel control accuracy from a worn sensor
• Emissions system faults tied to exhaust feedback
• Slow sensor response during cold operation

Installation Notes and Tips

• Verify the exact position on your vehicle before ordering; this part is listed for front, rear, and right positions depending on application.
• Confirm thread size and connector shape match the original sensor before installation.
• Inspect the harness routing and connector condition during replacement.
• Use the vehicle application details to confirm fitment for 1990-1992 Toyota Land Cruiser, 1989-1991 Toyota Pickup with California Emission System, 1988 Chevrolet Nova, 1988 Toyota Corolla, and 1985-1987 Toyota Land Cruiser.

Quality Assurance

Delphi builds aftermarket parts using OE experience and supplier knowledge developed through decades of original equipment involvement. The ES10822 reflects that heritage with a fitment-focused design for the specified Toyota and Chevrolet applications.