Delphi GN10172 Ignition Coil

Ignition Coil for Chrysler, Dodge, and Jeep

The Delphi GN10172 ignition coil is built for HEI ignition systems and direct replacement service on a wide range of Chrysler, Dodge, Plymouth, and Jeep vehicles. It uses a pin-style, male terminal design with two round pin connectors and one high-voltage terminal, and it is supplied without a module.

• HEI ignition coil for distributor ignition applications
• Pin terminal design with 2 male terminals
• Interface: 2 round pin connectors and 1 HV terminal
• No module included
• Package contents: ignition coil and instruction sheet

OE-Style Construction and Fitment

Delphi GN10172 is backed by more than a century of OE experience and engineering knowledge used in aftermarket replacement parts. That OE heritage matters when replacing an ignition coil on a 1990-1997 Dodge Dakota, 1994-1997 Dodge Ram 1500, or 1991-1997 Jeep Cherokee with round terminals, where consistent spark output and correct connector style are important for reliable engine operation. This part also fits applications such as 1991-1995 Dodge Caravan, 1991-1994 Chrysler LeBaron, and 1993-1997 Jeep Grand Cherokee with round terminals.

This part cross-references Standard Ignition UF-97 and WAI CUF97 for the same application.

Common Problems This Coil Can Address

• Hard starting caused by weak or inconsistent ignition spark
• Misfire under load from a failing coil
• Rough idle related to ignition voltage loss
• Intermittent stalling tied to coil breakdown
• Loss of spark on HEI-equipped ignition systems

Installation Notes

Verify the connector style, terminal count, and vehicle application before installation. This coil is listed for round-terminal Jeep applications and multiple Dodge and Plymouth models across 1990-1997. Confirm that your vehicle uses an HEI-style ignition coil and that no module is required for your setup. Use the included instruction sheet during installation and inspect related ignition components for wear before final assembly.

Quality Assurance

Delphi builds this ignition coil using OE-focused engineering and manufacturing knowledge developed through long-term supplier experience with major automakers. The GN10172 is designed as a direct replacement part for the listed applications, including Dodge Ram 2500, Dodge B3500, and Jeep Wrangler models with round terminals.