Delphi HP10141 Fuel Pump Hanger Assembly

Fuel Pump Hanger Assembly for Ford Ranger and Mazda B-Series

Delphi HP10141 is an in-tank fuel pump hanger assembly for gas applications that combines the pump, fuel level sender, seal, and strainer support in one OE-style replacement package. It is built for 12-volt systems with a quick-connect outlet and is suited for Ford Ranger and Mazda B2300, B3000, and B4000 models within the listed fitment range.

Key Features

• In-tank electric fuel pump hanger assembly for gasoline systems
• 12.0-volt operation with a 7-amp average current draw
• Maximum pressure rating of 80.0 and system pressure of 36 psi
• Quick-connect outlet with two outlets and 0.375 in. outlet outside diameter
• Fuel level sender assembly included with resistance range of 15.0 ohms empty to 160.0 ohms full
• Gasket or seal included, along with an external strainer
• Standard replacement design for OE-style service

Detailed Description

Delphi HP10141 fuel pump hanger assembly is engineered for direct replacement service on 1989-1997 Ford Ranger and 1994-1997 Mazda B2300, B3000, and B4000 applications. Delphi draws on OE experience and supplier knowledge to deliver an aftermarket fuel delivery component that matches the needs of the original system layout, including the in-tank pump design, pin terminals, male terminal configuration, and integrated fuel level sender. This part cross-references Airtex Fuel Pumps E2002 and Carter P74123 for the same application. The HP10141 is a practical choice when servicing a Ford Ranger fuel pump hanger assembly or replacing a Mazda B-Series in-tank fuel pump module.

Common Repair Symptoms

• Hard starting or extended crank time from weak fuel delivery
• Engine hesitation, stumble, or loss of power under load
• Inaccurate fuel gauge readings from a worn sender assembly
• Fuel pressure that falls below the required 36 psi system pressure
• Pump noise or intermittent operation from an aging in-tank unit

Installation Notes and Tips

Before installation, clean the fuel tank thoroughly to help prevent future seal problems, as noted in the fitment data. Verify the electrical connector, quick-connect outlet, and sender resistance range before final assembly. Confirm the vehicle uses the listed in-tank gasoline fuel system and compare the original hanger layout to the Delphi HP10141 before installation.

Quality Assurance

Delphi builds this replacement part using more than a century of OE experience and knowledge gained from supplying major automakers. The result is a standard replacement fuel pump hanger assembly intended to meet the demands of everyday fuel delivery service on Ford Ranger and Mazda B-Series trucks.