Delphi PS10082 Manifold Absolute Pressure Sensor

Delphi PS10082 Manifold Absolute Pressure Sensor

The Delphi PS10082 manifold absolute pressure sensor is built for direct replacement on a wide range of Buick, Pontiac, Oldsmobile, Chevrolet, and Geo applications. It uses OE-based engineering and a bolt-on design to help restore accurate intake manifold pressure readings for proper engine management.

Key Features

• Manifold Absolute Pressure Sensor for emission control and engine sensor replacement
• Bolt-on mount type for straightforward installation on the intended application
• Black oval connector with 1 connector, 3 terminals, and pin-style terminals
• Male connector gender with female terminal gender
• Plastic sensor body for OE-style fit and packaging
• Includes manifold absolute pressure sensor and instruction sheet
• Delphi PS10082 is backed by OE heritage and aftermarket engineering experience

Detailed Description

Delphi PS10082 is a manifold absolute pressure sensor engineered for vehicles that rely on accurate manifold pressure input for fuel and ignition control. This part number is listed for applications including 1997-2004 Buick Regal, 1996-2003 Buick Park Avenue, 1992-2003 Pontiac Bonneville, and 1997-2003 Pontiac Grand Prix, along with additional Buick, Oldsmobile, Chevrolet, Pontiac, and Geo models. If you are replacing a failing MAP sensor on a Buick Regal, Pontiac Grand Prix, or Buick Park Avenue, this Delphi unit provides the OE-style configuration needed for a proper repair.

This part cross-references Standard Ignition AS4 and Walker Products 225-1008 for the same application.

Common Issues This Sensor Can Address

• Rough idle caused by inaccurate manifold pressure readings
• Hard starting or extended crank conditions related to sensor signal loss
• Check engine light triggered by MAP sensor faults
• Poor throttle response from incorrect engine load data
• Fuel mixture and drivability problems tied to a failing intake pressure sensor

Installation Notes and Tips

Verify connector shape, terminal count, and mount style before installation. The PS10082 uses a black oval connector, 3 terminals, and a bolt-on design, so matching the original sensor configuration is important for a clean repair. Inspect the connector and wiring for corrosion or damage before installing the new sensor, and confirm the intake manifold port is clean and unobstructed.

Quality Assurance

Delphi builds this sensor using OE experience developed through long-term supply relationships with major automakers. That OE heritage is reflected in the part’s design, connector layout, and application coverage for select Buick, Pontiac, Oldsmobile, Chevrolet, and Geo vehicles.