Delphi SS11381 Engine Camshaft Position Sensor

Engine Camshaft Position Sensor for OE Fitment

Delphi SS11381 is an engine camshaft position sensor built for direct replacement service on a wide range of Chrysler, Dodge, Jeep, Ram, and select Mitsubishi applications. It uses a black housing with a 3-pin male terminal layout, oval female connector, and no included wiring harness or mounting bracket.

Backed by Delphi’s OE heritage and decades of supplier experience, this camshaft position sensor is built with the same application knowledge used in original equipment development. It is a practical choice for drivers servicing Chrysler 300, Dodge Charger, Jeep Grand Cherokee, and Ram 1500 models that require accurate camshaft signal input.

Key Features

• Delphi SS11381 engine camshaft position sensor
• Black sensor body with oval connector shape
• 3-terminal design with female connector and male terminals
• Instruction sheet included in the package contents
• No wiring harness included
• No mounting bracket included
• OE-based design informed by Delphi’s supplier experience

Detailed Description

The Delphi SS11381 camshaft position sensor monitors camshaft position and sends the signal needed for engine management timing. It is compatible with many 2008-2023 Chrysler 300, Dodge Challenger, Dodge Charger, Jeep Grand Cherokee, Jeep Wrangler, Ram 1500, Ram 2500, and Ram 3500 applications, along with additional coverage for Dodge Durango, Liberty, Nitro, Dakota, Viper, and related platforms. This part number, SS11381, is also cross-referenced to Standard Ignition PC823 for the same application.

Delphi builds aftermarket parts using OE experience and knowledge developed through long-term supplier relationships with major automakers. That background supports consistent fitment and signal performance for vehicles that depend on accurate camshaft position data for starting, drivability, and engine control.

What It Helps Address

• Hard starting or extended crank conditions related to camshaft signal loss
• Intermittent stalling caused by an unstable camshaft position signal
• Check engine light concerns tied to camshaft sensor faults
• Rough idle or drivability issues when engine timing input is incorrect
• Misfire or synchronization problems on Chrysler, Dodge, Jeep, and Ram engines

Installation Notes and Tips

Verify connector style, terminal count, and mounting location before installation. The SS11381 uses a 3-pin oval female connector with male terminals, so the vehicle harness should match that configuration. Inspect the connector for corrosion, damaged pins, or oil intrusion before replacing the sensor, and clear diagnostic trouble codes after installation if required by the vehicle.

Compatible With 2008-2023 Chrysler 300, 2008-2023 Dodge Challenger, 2008-2023 Dodge Charger, 2011-2023 Dodge Durango, 2008-2023 Jeep Grand Cherokee, and 2011-2023 Ram 1500 applications, among others listed in the fitment data.

Quality Assurance

Delphi’s OE heritage and supplier experience are built into this aftermarket camshaft position sensor. The SS11381 is engineered with application-specific knowledge for direct replacement service across supported Chrysler, Dodge, Jeep, Ram, and Mitsubishi vehicles.