Delphi SS11657 ABS Wheel Speed Sensor - Front Right or Rear Right

OE-Style ABS Wheel Speed Sensor for Toyota

Delphi SS11657 is an ABS wheel speed sensor built for front right and rear right applications on select Toyota trucks and SUVs. It draws on Delphi’s OE heritage and decades of supplier experience to deliver the fit and signal consistency expected in brake system service.

Compatible With Toyota Sequoia and Toyota Tundra applications, this sensor is a direct replacement choice for diagnosing wheel speed signal faults on the front right or rear right position, depending on vehicle configuration.

Key Features

• ABS wheel speed sensor for brake system service
• Position-specific fitment for front right and rear right locations
• 1 female connector with 2 male terminals
• Square connector shape with pin terminal type
• No wiring harness included
• Package contents: ABS wheel speed sensor and instruction sheet
• Delphi part number SS11657

Detailed Description

Delphi SS11657 is engineered as an OE-style replacement ABS wheel speed sensor for 2007-2017 Toyota Tundra front right and rear right applications, plus 2008-2017 Toyota Sequoia front right applications. It is built with Delphi’s OE knowledge from supplying major automakers, helping maintain the wheel speed input needed by the ABS control system. If you are replacing a failed Toyota Tundra ABS sensor or a Toyota Sequoia front right wheel speed sensor, SS11657 provides a direct-fit service part for the listed positions.

This part cross-references Standard Ignition ALS1790 for the same application.

Common Problems This Part Can Address

• ABS warning light caused by a faulty wheel speed sensor
• Intermittent or inaccurate wheel speed signal at the front right or rear right wheel
• Brake system fault codes related to wheel speed input
• Loss of ABS function from sensor wear or electrical failure
• Drivability concerns tied to incorrect wheel speed data

Installation Notes and Tips

Confirm the exact position before installation, since this sensor is listed for front right and rear right locations depending on the vehicle. Verify connector shape, terminal count, and mounting style against the original part before replacement. The sensor is supplied without mounting hardware and without a wiring harness, so reuse or source any required vehicle-specific components separately.

Quality Assurance

Delphi builds this replacement part using OE experience and supplier knowledge developed over many years in the automotive industry. That background supports consistent fitment and dependable brake system service for Toyota Sequoia and Toyota Tundra applications covered by the listing.