Delphi SS11682 ABS Wheel Speed Sensor - Rear Right

Rear Right ABS Sensor for Ford Focus

The Delphi SS11682 ABS wheel speed sensor is built for rear right applications on 2008-2011 Ford Focus models. It uses a built-in wiring harness and a female round connector to support a direct-fit replacement for the original sensor location.

Delphi draws on OE experience and supplier knowledge developed over decades of working with major automakers, bringing that background into aftermarket brake sensor replacement parts like the SS11682.

Key Features

• ABS wheel speed sensor for the rear right position
• Fits 2008-2011 Ford Focus, rear right
• Built-in wiring harness with 22.75-inch harness length
• 1 round female connector with 2 male terminals
• Package contents include the ABS wheel speed sensor and instruction sheet
• Delphi SS11682 replacement part number for OE-style service

Detailed Description

The Delphi SS11682 is an ABS wheel speed sensor for the rear right side of select Ford Focus vehicles. It is engineered with a built-in wiring harness, a single round connector, and a two-terminal layout to match the original sensor configuration used on 2008-2011 Ford Focus models. If you are replacing a failed rear wheel speed sensor on a Ford Focus, the SS11682 provides a direct replacement option identified by Delphi part number SS11682.

This part cross-references Standard Ignition ALS1727 for the same application.

Common Problems This Part Can Address

• ABS warning light illuminated on the dash
• Wheel speed signal loss at the rear right wheel
• Traction control or stability system faults tied to wheel speed input
• Intermittent ABS operation caused by a damaged sensor harness or connector
• Brake system fault codes related to the rear wheel speed sensor circuit

Installation Notes and Tips

Verify rear right placement before installation and compare the connector style, terminal count, and harness length to the original sensor. On 2008-2011 Ford Focus applications, confirm the mounting point and routing path so the built-in harness follows the factory layout. Delphi SS11682 is supplied without mounting hardware, so reuse or source any required fasteners separately if needed.

Quality Assurance

Delphi applies OE heritage and supplier experience from work with leading automakers to its aftermarket brake sensors. The SS11682 is built to support accurate wheel speed signal replacement for the specified Ford Focus fitment.