Delphi SS20350 ABS Wheel Speed Sensor - Rear

Rear ABS Wheel Speed Sensor for Select GM Vehicles

Delphi SS20350 is a rear ABS wheel speed sensor built for select Buick, Cadillac, and Chevrolet applications. It uses a square female connector, a blade terminal design, and an included wiring harness to match the original sensor layout on covered vehicles.

Built from Delphi’s OE experience and aftermarket knowledge, this sensor supports accurate wheel speed signal input for the ABS system on vehicles such as the Buick Cascada, Buick Verano, Cadillac ELR, Chevrolet Cruze, Chevrolet Cruze Limited, and Chevrolet Volt.

Key Features

• Rear ABS wheel speed sensor for covered applications
• Square connector with 1 female connector and 2 male blade terminals
• Wiring harness included with a 22.4 length harness
• Package contents include the ABS wheel speed sensor and instruction sheet
• OE-focused design from Delphi, part number SS20350

Detailed Description

Delphi SS20350 is an ABS wheel speed sensor for the rear position on select GM vehicles. It is engineered with a built-in wiring harness and a square connector layout to match the original sensor configuration used on applications such as the 2011-2015 Chevrolet Cruze rear, 2011-2015 Chevrolet Volt rear, 2012-2017 Buick Verano rear, 2014-2016 Cadillac ELR rear, 2016 Chevrolet Cruze Limited rear, and 2016-2019 Buick Cascada rear. Delphi draws on more than a century of OE supply experience, and that heritage is reflected in the fit and electrical design of SS20350.

This part cross-references Standard Ignition ALS2056 for the same application.

What It Helps Address

• ABS warning light caused by a failed rear wheel speed sensor
• Intermittent wheel speed signal loss at the rear axle
• ABS system faults related to damaged sensor wiring
• Traction control or stability control concerns tied to wheel speed input
• Brake system diagnostic trouble codes linked to the rear sensor circuit

Installation Notes

• Verify rear position fitment before ordering; this sensor is not listed for front applications.
• Inspect the connector, harness routing, and mounting point before installation.
• Compare the original sensor shape, terminal style, and harness length to the replacement part.
• Follow the included instruction sheet and clear diagnostic codes after installation if required.

Quality Assurance

Delphi builds this sensor using OE-based engineering knowledge developed through long-term supplier experience with major automakers. Part number SS20350 is made to support the original electrical and fitment requirements of the listed rear ABS applications.