Delphi SS21441 ABS Wheel Speed Sensor - Rear Left

Rear Left ABS Wheel Speed Sensor for Honda CR-V

Delphi SS21441 is a rear left ABS wheel speed sensor for 2017-2022 Honda CR-V models. It is built for accurate wheel speed signal reporting, helping the ABS system monitor rear wheel rotation with OE-level calibration.

Key Features

• Fits 2017-2022 Honda CR-V, rear left
• ABS wheel speed sensor for brake system monitoring
• OE-standard testing and calibration for accurate readings
• Black connector with square connector shape
• Male connector and male terminal design
• Wiring harness length: 1318
• Package contents: ABS wheel speed sensor and instruction sheet

Product Details

Delphi SS21441 is an ABS wheel speed sensor engineered for the rear left position on the Honda CR-V. Delphi validates its vehicle sensors through OE development methods and product testing, with calibration aimed at consistent signal output and reduced repeat repairs. This part cross-references Standard Ignition ALS3133 for the same application.

For shoppers searching for a rear left ABS wheel speed sensor for 2017-2022 Honda CR-V, Delphi SS21441 provides the correct fitment and connector configuration for the listed application. The sensor uses a two-connector, two-terminal layout with a black square connector and no included wiring harness.

Common Issues This Sensor Can Address

• ABS warning light triggered by a failed rear wheel speed sensor
• Loss of wheel speed signal at the rear left wheel
• Erratic ABS system input during braking
• Fault codes related to rear wheel speed sensor performance
• Intermittent braking control feedback from a damaged sensor

Installation Notes

Verify rear left placement before installation and compare the connector shape, terminal count, and harness length to the original part. Inspect the wheel hub area, wiring routing, and connector condition before fitting the new sensor. Clear stored ABS codes after installation and confirm proper system operation with a scan tool.

Quality Assurance

Delphi sensors are developed and validated to OE standards, with testing and calibration focused on accurate readings for dependable brake system performance. Part number SS21441 is built to meet the listed application requirements for the Honda CR-V.