Delphi TA1071 Steering Tie Rod End - Left Outer

Delphi TA1071 Front Left Outer Tie Rod End

Delphi TA1071 is a standard replacement steering tie rod end for the front left outer position. It is built with OE-focused dimensional and material analysis to help maintain proper steering geometry on supported Audi applications, including Audi A6, A6 Quattro, S6, 100, 100 Quattro, 200, 200 Quattro, S4, and V8 Quattro models.

Key Features

• Front left outer steering tie rod end
• Black coated finish with steel housing and steel tie rod material
• Pre-greased design; no grease fitting required
• Dust boot included with chloroprene rubber construction
• Mounting hardware included
• Bent style with threaded stud design
• Clockwise thread direction on both ends
• Standard replacement part number TA1071

Detailed Description

Delphi TA1071 is engineered for steering service where precise fit and consistent joint movement matter. The part uses a steel housing, plastic bearing material, and a coated black finish for a durable replacement assembly. Its pre-greased, non-greaseable construction and included dust boot help simplify service while protecting the joint from contamination. Delphi applies OE-level testing to aftermarket steering components, including exposure to extreme temperatures and extended salt spray testing, to verify durability under demanding conditions. This part cross-references TRW JTE141 for the same application.

Vehicle Fitment

• Fits 1995-1998 Audi A6, left outer, with 16mm threads.
• Fits 1998 Audi A6 Quattro, left outer, with 16mm threads; to chassis # 4A-W-0005000.
• Fits 1995-1997 Audi A6 Quattro, left outer, with 16mm threads.
• Fits 1995-1997 Audi S6, left outer.
• Fits 1989-1994 Audi 100, left outer, with 16mm threads.
• Fits 1992-1994 Audi 100 Quattro, left outer.
• Fits 1992-1994 Audi S4, left outer.
• Fits 1990-1994 Audi V8 Quattro, left outer.
• Fits 1989-1991 Audi 100 Quattro, left outer, with 16mm threads.
• Fits 1990-1991 Audi 200, left outer, with 16mm threads.
• Fits 1989-1991 Audi 200 Quattro, left outer, with 16mm threads.
• Fits 1989 Audi 200, left outer.

Common Steering Issues It Can Address

• Loose or imprecise steering feel at the front left outer linkage
• Excessive play from a worn tie rod end joint
• Uneven tire wear caused by steering linkage wear
• Clunking or knocking from the front steering assembly
• Restoration of correct toe adjustment after steering service

Installation Notes and Tips

Verify the vehicle’s thread size and chassis notes before ordering, especially on Audi A6 Quattro applications with 16mm threads and the 1998 A6 Quattro chassis break. Replace the tie rod end with the steering system secured, then perform a professional wheel alignment after installation. Confirm the front left outer position and thread direction match the original component before final tightening.

Quality Assurance

Delphi uses OE-based engineering and validation methods for its steering portfolio, including dimensional and material analysis plus environmental testing for temperature extremes and corrosion exposure. That approach supports consistent fitment and dependable service performance for the TA1071 steering tie rod end.