Delphi TA1145 Steering Tie Rod End - Inner

Delphi TA1145 Front Inner Tie Rod End

Delphi TA1145 is a straight steering tie rod end built for front inner steering applications on select Honda vehicles. It combines OE-based dimensional analysis with material-focused testing to support precise steering linkage fitment for Honda Accord, Civic, and Prelude applications.

Key Features

• Front inner steering tie rod end for select Honda applications
• Straight design with male/male end configuration
• Pre-greased and coated for service-ready installation
• Steel housing and steel tie rod construction
• Adjustable design for steering linkage alignment
• Mounting hardware included
• Delphi part number TA1145

Detailed Description

Delphi TA1145 is a standard replacement steering tie rod end engineered for front inner use. It features a 12.0 mm thread diameter on both ends, clockwise thread direction, and a 1.25 thread pitch on the end 2 side. The unit uses a steel housing, steel tie rod material, and a POM bearing material, with a coated black finish for added corrosion resistance. Delphi validates its steering components through extreme temperature and salt-spray testing, along with dimensional and material analysis to help maintain OE-style compatibility. This part cross-references Beck/Arnley 101-4094 for the same application.

Vehicle Fitment

• Fits 1982-1989 Honda Accord, inner
• Fits 1980-1983 Honda Civic, inner
• Fits 1979-1982 Honda Prelude, inner

What This Part Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering response
• Uneven front tire wear caused by steering linkage wear
• Clunking or knocking from the front steering system
• Alignment instability after steering component wear

Installation Notes

Install on the front inner steering position and verify thread direction, thread diameter, and overall length before assembly. Because this is an adjustable steering component, a professional wheel alignment should be performed after installation. Confirm vehicle-specific fitment for 1982-1989 Honda Accord, 1980-1983 Honda Civic, and 1979-1982 Honda Prelude applications before service.

Quality Assurance

Delphi applies OE-focused engineering to its aftermarket steering portfolio and subjects parts to temperature extremes below -40 degrees C and above 120 degrees C, plus 720 hours of salt-spray exposure. Delphi TA1145 is built to support consistent fit and durability in steering service.