Delphi TA1196 Steering Tie Rod End - Outer

Delphi TA1196 Front Outer Tie Rod End

Delphi TA1196 is a standard replacement steering tie rod end built for front outer applications on select Mitsubishi, Dodge, and Chrysler vehicles. It combines OE-focused dimensional control with corrosion-resistant construction to support precise steering response in service.

Key Features

• Front outer steering tie rod end for select applications
• Pre-greased with a dust boot included
• Steel housing and steel tie rod construction
• Coated black finish for added corrosion resistance
• Male threaded ends with straight design
• Mounting hardware included
• Standard replacement part number TA1196

Detailed Description

Delphi TA1196 is engineered as an OE-style steering tie rod end for vehicles that need accurate front-end steering linkage service. Delphi applies dimensional and material analysis to help maintain proper compatibility with the original steering geometry, while the part is tested for extreme temperature exposure and salt spray resistance to support durability in demanding road conditions. This tie rod end is pre-greased, includes a dust boot, and uses a coated steel housing with a plastic bearing material and chloroprene rubber dust boot.

Compatible With 1983-1994 Mitsubishi Mighty Max, outer; 1987-1993 Dodge Ram 50, outer; 1983-1985 Dodge Ram 50, outer; 1983-1991 Mitsubishi Montero, outer; 1989 Chrysler Conquest, outer; 1987-1989 Dodge Raider, outer; and 1983-1986 Dodge Power Ram 50, outer. This part cross-references Beck/Arnley 101-3643 for the same application. Delphi TA1196 also cross-references Mevotech Supreme MES2246L for the same application.

Common Repair Uses

• Restores steering linkage movement when the original tie rod end is worn
• Addresses looseness or play in the front outer steering connection
• Helps correct steering wander or imprecise road feel
• Supports replacement of a damaged dust boot or contaminated joint
• Helps resolve uneven tire wear caused by steering end wear

Installation Notes and Tips

Install on the front outer steering position only. Verify thread direction, thread diameter, and cone dimensions before installation to confirm proper match to the vehicle’s steering linkage. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Delphi TA1196 is not adjustable, so final alignment should be set at the vehicle level.

Quality Assurance

Delphi builds this steering component using OE-focused engineering practices and validation testing that includes temperature cycling from below -40 degrees C to above 120 degrees C, along with extended salt spray exposure. The result is a replacement tie rod end designed around OE compatibility and durability expectations for front steering service.