Delphi TA1203 Steering Tie Rod End - Left Inner

Delphi TA1203 Front Left Inner Tie Rod End

Delphi TA1203 is a standard replacement steering tie rod end built for the front left inner position. It is a bent, adjustable steel component with a coated black finish, pre-greased construction, and mounting hardware included for service replacement work.

For drivers searching for a front left inner tie rod end for Honda Civic or similar steering repair applications, this Delphi part number TA1203 is built around OE-style dimensional and material analysis. It is cross-referenced to Mevotech Original Grade GEV119 and MOOG EV119 for the same application.

Key Features

• Front left inner steering tie rod end
• Adjustable bent design for steering linkage service
• Steel housing and steel tie rod material
• Pre-greased, with no grease fitting required
• Coated black finish for added surface protection
• Female end 1 with counterclockwise thread direction
• Mounting hardware included
• Standard replacement grade

Detailed Description

Delphi TA1203 is engineered as a steering tie rod end for the front left inner location, where precise steering linkage movement and secure fitment matter. The steel housing, 16.0 mm thread diameter, and 19.0 mm tube diameter support a durable replacement for worn steering components. Delphi validates its steering portfolio with extreme temperature exposure and extended salt-spray testing, then uses dimensional and material analysis to match OE and aftermarket requirements more closely.

This part number TA1203 is a practical choice for steering repair on vehicles such as Honda Civic applications that require a front left inner tie rod end. It also cross-references Monroe Shocks & Struts 172286 for the same application.

What It Helps Address

• Loose or vague steering feel
• Excessive play in the steering linkage
• Uneven front tire wear caused by worn steering components
• Clunking or knocking from the front steering system
• Steering pull related to worn inner tie rod hardware

Installation Notes and Tips

Install TA1203 at the front left inner steering position only. Verify thread direction, end gender, and adjustment range before alignment work begins. Because this tie rod end is pre-greased and does not use a grease fitting, no routine greasing point is provided. After installation, a professional wheel alignment is recommended to restore steering geometry.

Quality Assurance

Delphi applies OE-focused testing and material validation to its steering components, including temperature cycling below -40 degrees C and above 120 degrees C, plus 720 hours of salt-spray exposure. That testing supports consistent fit and corrosion resistance for replacement steering service on Honda Civic and other listed applications. Part number TA1203 is built as a standard replacement steering component.